3044C Industrial Engine and Engines for Caterpillar Built Machines Engine Oil Cooler - Remove Caterpillar


Engine Oil Cooler - Remove
`
1.1. Removal Procedure

Removal Procedure

Start By:

  1. Remove the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.



NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "AVSpare Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on AVSpare products.

Dispose of all fluids according to local regulations and mandates.


  1. Drain the engine coolant and the engine oil from the engine oil cooler into a suitable container. Refer to Operation and Maintenance Manual for the procedure on draining the engine coolant and the engine oil.



    Illustration 1g01035409

  1. Remove bolts (1). Remove engine oil cooler (2) .



    Illustration 2g01035412



    Illustration 3g01035413

  1. Remove nuts (3). Remove cover (4) from oil cooler assembly (7). Remove gaskets (5) and O-ring seals (6) .

Information System:

3044C Industrial Engine and Engines for Caterpillar Built Machines Fuel Injection Lines - Remove and Install - Turbocharged Engines
980G Series II Wheel Loader Cooling System Coolant Sample (Level 1) - Obtain
854G Wheel Tractor and 992G Wheel Loader Power Train Axle Shaft - Remove and Install
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Diagnostic Code List
2003/06/02 New Guard Assembly for the Tilt Position Sensor Is Used {5736}
613C Series II Wheel Tractor Power Train Torque Converter - Assemble
3044C Industrial Engine and Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
613C Series II Wheel Tractor Power Train Torque Converter - Disassemble
3044C Industrial Engine and Engines for Caterpillar Built Machines Water Pump - Remove and Install
3044C Industrial Engine and Engines for Caterpillar Built Machines Engine Oil Relief Valve - Remove and Install
613C Series II Wheel Tractor Power Train Torque Converter - Install
2003/05/19 Correction to Testing and Adjusting , "Ride Control Accumulator Recharging Procedure" {5077}
854G Wheel Tractor and 992G Wheel Loader Power Train Transmission Hydraulic Control Valve - Install
3044C Industrial Engine and Engines for Caterpillar Built Machines Engine Oil Cooler - Install
AD30 Underground Articulated Truck Machine Electrical System Brake Oil Temperature
966G II and 972G II Wheel Loaders Monitoring System
854G Wheel Tractor and 992G Wheel Loader Power Train Transmission Hydraulic Control Valve - Remove
TH220B, TH330B and TH340B Telehandlers Machine Systems Carriage Cylinder (Sideshift)
3044C Industrial Engine and Engines for Caterpillar Built Machines Turbocharger - Remove
854G Wheel Tractor and 992G Wheel Loader Power Train Final Drive and Wheel - Disassemble
988H Wheel Loader Operator Controls
3044C Industrial Engine and Engines for Caterpillar Built Machines Turbocharger - Install
854G Wheel Tractor and 992G Wheel Loader Power Train Final Drive and Wheel - Assemble
988G Wheel Loader Engine Oil Level - Check