Removal Procedure
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 8S-2264 | Puller Group | 1 |
| ZZ | 6V-9509 | Face Seal Plug | 2 |
| 6V-9830 | Cap As | 2 | |
| 6V-9507 | Face Seal Plug | 1 | |
| 6V-9828 | Cap As | 1 | |
Start By:
- Release the system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies.
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
 |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
 |
- Remove bolts (1) and remove guard (2) .
 | |
| Illustration 1 | g00993216 |
- Disconnect hose assemblies (3) .
 | |
| Illustration 2 | g00993218 |
- Disconnect harness assemblies (4) .
 | |
| Illustration 3 | g00993220 |
- Open fan housing (5) .
 | |
| Illustration 4 | g00993222 |
- Remove bolts (6) and remove fan guard (7) .
 | |
| Illustration 5 | g00993223 |
- Remove nut (8) .
 | |
| Illustration 6 | g00993225 |
- Install Tooling (A) and remove fan (9) .
 | |
| Illustration 7 | g00993226 |
- Remove bolts (10) and remove fan motor (11) .
 | |
| Illustration 8 | g00993229 |