C7 Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install Caterpillar


Piston Cooling Jets - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure

Start By:

  1. Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove".


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 1g00987444

  1. Remove bolt (2) and piston cooling jet (1) from each cylinder.

Installation Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 2g00987444

  1. Position piston cooling jet (1) in the cylinder block. Install bolt (2). Tighten bolt (2) to a torque of 28 ± 7 N·m (21 ± 5 lb ft).

End By:

  1. Install the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Install".

Information System:

C11 and C13 Engines for Caterpillar Built Machines Variable Valve Actuators - Inspect/Adjust
C7 Engines for Caterpillar Built Machines Rocker Shaft - Disassemble
953C Track-Type Loader Coolant Sample (Level 2) - Obtain
953C Track-Type Loader Coolant Sample (Level 1) - Obtain
C7 Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
D5N Track-Type Tractor Power Train Track Roller - Install
D5N Track-Type Tractor Power Train Track Roller - Remove
D6N Track-Type Tractor Power Train Recoil Spring - Install
D6N Track-Type Tractor Power Train Recoil Spring - Remove
TH210 and TH215 Telehandlers Lifting Capacities
953C Track-Type Loader Emissions Certification Film
C7 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
651E and 657E Wheel Tractor-Scrapers Hydraulic System Relief Valve (Push-Pull) - Test and Adjust
938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Pilot Operated Hydraulic Control - Disassemble
938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Pilot Operated Hydraulic Control - Assemble
611 and 615C Series II Wheel Tractor-Scrapers Steering System General Information
611 and 615C Series II Wheel Tractor-Scrapers Steering System Piston Pump (Secondary Steering)
611 and 615C Series II Wheel Tractor-Scrapers Steering System Steering System Troubleshooting
C7 Engines for Caterpillar Built Machines Camshaft Gear - Remove and Install
980G Series II Wheel Loader Electrohydraulic System Hydraulic Fan Speed - Test and Adjust
2003/03/24 New Flash Software Allows Calibrations of the Power Train to be Performed by Using the Caterpillar Electronic Technician {0783, 0785, 7620}
2003/04/14 Correction to Testing And Adjusting , "Transmission Testing and Location of The Pressure Taps" {3030, 3073}
2003/04/21 Correction to Testing and Adjusting , "Pressure Tap Locations" {3030}
C7 Engines for Caterpillar Built Machines Unit Injector - Remove