D5N Track-Type Tractor Power Train Track Roller - Install Caterpillar


Track Roller - Install
`
1.1. Installation Procedure

Installation Procedure

Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-7519     Hydraulic Pump     1    
8S-7611 Tube     1    
8S-7650 Cylinder As     1    
8S-7615 Pin     1    
B     FT-1309     Lifting Fork     1    



    Illustration 1g00987342

  1. Position Tooling (B) and a suitable lifting device.

  1. Position track roller (2) from the machine. The weight of the track roller is 30 kg (66.0 lb).

  1. Install bolts (3) into each side of the roller.



    Illustration 2g00987238



    Illustration 3g00987264

  1. Remove Tooling (A) and the blocks.

  1. Install the rock guards, if necessary.

  1. Tighten the track. For the proper procedure, refer to Operation and Maintenance Manual, "Track - Check/Adjust" for the machine that is being serviced.

Information System:

D5N Track-Type Tractor Power Train Track Roller - Remove
D6N Track-Type Tractor Power Train Recoil Spring - Install
D6N Track-Type Tractor Power Train Recoil Spring - Remove
TH210 and TH215 Telehandlers Lifting Capacities
953C Track-Type Loader Emissions Certification Film
C7 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
953C Track-Type Loader Engine Starting
C7 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
980G Series II Wheel Loader Electrohydraulic System Pump Performance (Pilot and Braking) - Test
C7 Engines for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
953C Track-Type Loader Daily Inspection
TH350B, TH355B, TH360B, TH460B and TH560B Telehandlers Power Train Drive and Steering Axle (Front) - Install
C7 Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
953C Track-Type Loader Coolant Sample (Level 1) - Obtain
953C Track-Type Loader Coolant Sample (Level 2) - Obtain
C7 Engines for Caterpillar Built Machines Rocker Shaft - Disassemble
C11 and C13 Engines for Caterpillar Built Machines Variable Valve Actuators - Inspect/Adjust
C7 Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
651E and 657E Wheel Tractor-Scrapers Hydraulic System Relief Valve (Push-Pull) - Test and Adjust
938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Pilot Operated Hydraulic Control - Disassemble
938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Pilot Operated Hydraulic Control - Assemble
611 and 615C Series II Wheel Tractor-Scrapers Steering System General Information
611 and 615C Series II Wheel Tractor-Scrapers Steering System Piston Pump (Secondary Steering)
611 and 615C Series II Wheel Tractor-Scrapers Steering System Steering System Troubleshooting