938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Metering Pump (HMU) - Install Caterpillar

Installation Procedure

Show/hide table

Illustration 1	g00278604

Note: Before installation, apply Tooling (A) to bolts (10).

1. Position plate (9) on the steering metering pump. Install bolts (10). The torque for bolts (10) is 55 ± 10 N·m (40 ± 7 lb ft).
   Show/hide table

   Illustration 2	g00278603

   Show/hide table

   Illustration 3	g00984698

2. Install steering metering pump (8).

   Note: The splines of the steering metering unit must align.

   Show/hide table

   Illustration 4	g00278602

3. Install bolts (7) at the base of the steering column. The torque for bolts (7) is 28 ± 7 N·m (21 ± 5 lb ft).
   Show/hide table

   Illustration 5	g00278601

4. Put the insulation and rubber mat (6) on the cab floor.
   Show/hide table

   Illustration 6	g00278600

5. Connect hose assemblies (5).
   Show/hide table

   Illustration 7	g00278599

6. Install brake control valve (4) and bolts (3).
   Show/hide table

   Illustration 8	g00278598

7. Install panel (2) and bolts (1).

8. Fill the hydraulic tank with oil. Refer to Operation and Maintenance Manual for the correct procedure.

End By:

1. Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".