938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Heater Coil

Heater Coil - Remove

938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems [RENR6081]

938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Diverter Valve (Quick Coupler) - Remove and Install

938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Pilot Operated Hydraulic Control (Joystick) - Install

OPERATOR STATION

AIR CONDITIONER GP

938G Wheel Loader and IT38G Integrated Toolcarrier Machine Systems Evaporator Coil - Remove and Install

938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Heater Coil - Remove

938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Heater Coil - Install

938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Blower Motor (Air Conditioner, Heater) - Remove

938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Machine Systems Blower Motor (Air Conditioner, Heater) - Install

1.1. Removal Procedure

Removal Procedure

Start By:

Remove the seat. Refer to Disassembly and Assembly, "Seat - Remove and Install".

Show/hide table

At operating temperature, the engine coolant is hot and under pressure.
Steam can cause personal injury.
Check the coolant level only after the engine has been stopped and the filler cap is cool enough to touch with the bare hand.
Remove the filler cap slowly to relieve pressure.

Cooling system conditioner contains alkali. Avoid contact with skin and eyes to prevent personal injury.

Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.

Show/hide table




Illustration 1	g00984408

Close valves (1A).
Show/hide table

Illustration 2 g00984409

Show/hide table

Illustration 3 g00984410
Remove screws (1) that secure cover (2).
Lift up cover (2). Disconnect wire (3). Remove cover (2).
Remove rubber mat (4) and the insulation from the cab floor.
Show/hide table

Illustration 4 g00284953
Remove bolts (6) and the washers. Remove cover (5).
Show/hide table

Illustration 5 g00284954
Remove cover (7).
Show/hide table

Illustration 6 g00984412
Remove control knobs (8), cover assembly (9) and air filter (9A) (not shown).
Show/hide table

Illustration 7 g00284956
Remove the bolts, the washers, and screws (11). Remove cover (10).
Show/hide table

Illustration 8 g00284959
Remove gaskets (12).
Show/hide table

Illustration 9 g00460919
Pull capillary tube (15) out of coil assembly (13). Carefully move the capillary tube away from the coil assembly.
Disconnect hose assemblies (14).
Show/hide table

Illustration 10 g00460920
Remove seals (17), bolts (18), and the washers from both ends of the coil assembly.
Remove heater core (16).