TH350B, TH360B, TH460B and TH560B Telehandlers Engine Supplement Engine Mount (Rear) - Install Caterpillar

Installation Procedure

1. Clean all parts and inspect all parts. If any parts are worn or damaged, use new AVSpare parts for replacement.

Show/hide table



Illustration 1	g00984296

2. The suitable lifting chain was attached to the bracket on the engine in the removal procedure in order to support the engine and the transmission. Refer to Disassembly and Assembly, "Engine Mounts (Rear) - Remove". The combined weight of the engine and the transmission is approximately 780 kg (1720 lb).

Show/hide table



Illustration 2	g00984278

Show/hide table



Illustration 3	g00984279

3. Install the upper half of mount (5) into the engine frame. Position bracket (7 ) onto the engine and install four bolts (8) and the washers.

4. Use the hoist to carefully lower the engine until bracket (7) is seated on the upper half of mount (5) .

5. Install sleeve (6), the lower half of mount (5), washer (4), bolt (1), two washers (2) and nut (3). Tighten the nut and the bolt to a torque of 775 ± 20 N·m (572 ± 15 lb ft).

6. Remove the lifting chain.

End By:

1. Install the air cleaner. Refer to Disassembly and Assembly, "Air Cleaner - Install".
2. Install the hood. Refer to Disassembly and Assembly, "Engine Enclosure - Remove and Install".