938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Power Train Drive Shaft (Center) - Remove and Install Caterpillar

Removal Procedure

Start By:

1. Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".

1. Park the machine on a flat, level surface. Lower the bucket to the ground. Chock the wheels in order to prevent the machine from rolling when the drive shaft is removed.

Show/hide table



Illustration 1	g00979814

2. Remove bolts (1) and remove straps (2) .

Show/hide table



Illustration 2	g00979816

3. Remove bolts (3) and remove straps (4). Remove center drive shaft (5) .

Installation Procedure

Show/hide table



Illustration 3	g00979816

1. Carefully install center drive shaft (5) .

2. Support center drive shaft (5). Install two straps (4) and bolts (3). The torque for bolts (3) is 71 ± 10 N·m (52 ± 7 lb ft).

Show/hide table



Illustration 4	g00979814

3. Install straps (2) and bolts (1). The torque for bolts (3) is 71 ± 10 N·m (52 ± 7 lb ft).

4. Lubricate the rear drive shaft.

End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".