826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Engine Supplement Fuel Cooler - Remove and Install Caterpillar


Fuel Cooler - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure


NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.

Dispose of all fluids according to local regulations and mandates.


------ WARNING! ------

Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.


  1. Turn the battery disconnect switch to the OFF position.

  2. Turn the fuel supply to the OFF position.


    Illustration 1g03712325
    Typical Example

  3. Disconnect hose assemblies (3).

  4. Remove bolts (1) and the washers. Remove fuel cooler (2).

Installation Procedure

  1. Install fuel cooler (2) in the reverse order of removal.

Information System:

D3K2, D4K2 and D5K2 Track-Type Tractor Systems Brake System
D6N Track-Type Tractor Calibration Error Codes
950 GC Wheel Loader Engine Supplement Refrigerant Compressor - Remove and Install
D6N Track-Type Tractor Electronic Control (Steering System)
C3.4B Engines DEF Module Does Not Respond
924K, 930K and 938K Wheel Loaders Fuel System Primary Filter (Water Separator) Element - Replace
2014/08/18 Improved Radiator Support Pin Assemblies and Support Bar Assemblies Are Now Used On D11T Track-Type Tractors Equipped With Copper Tube Grommeted Radiators {1353}
C3.4B Engines DEF Concentration Is Incorrect
950 GC Wheel Loader Machine Systems Loader Frame from Rear Frame - Separate
D6N Track-Type Tractor Additional Electrical Components
D7E Track-Type Tractor Operating Technique Information
950M and 962M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Electronic Control (Power Train System)
Installation of No. 7 Ripper (RMP) on D7R Track-Type Tractor{6310, 6324, 6325}
950 GC Wheel Loader Machine Systems Refrigerant Condenser - Remove and Install
Installation of 7S (S/N: RL7) and 7SU (S/N: RT7) on D7R Track-Type Tractor{6050, 6051, 6060, 6078}
986H Wheel Loader Axle Shaft - Remove and Install
D6N Track-Type Tractor HVAC System
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Engine Supplement Hydraulic Oil Cooler - Remove and Install
926M, 930M, and 938M Small Wheel Loader Diesel Exhaust Fluid Filter - Replace
986H Wheel Loader Fixed Axle (Front) - Remove and Install
D5R2 and D6R2 Track-Type Tractors General Information
950 GC Wheel Loader Machine Systems Refrigerant Receiver-Dryer - Remove and Install
D6N Track-Type Tractor Location of Components (HVAC System)
826K Landfill Compactor, 825K Soil Compactor and 824K Wheel Dozer Engine Supplement Engine Oil Filter and Oil Filter Base - Remove and Install