| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 138-7575 | Link Bracket | 3 |
| 1U-9200 | Lever Puller Hoist | 1 | |
Start By:
- Remove the torque converter, the transmission, and the transfer gears.
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be cleaned thoroughly. This will help to prevent dirt from entering the internal mechanism.
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
 |
|
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
- Attach a suitable lifting device to the transmission oil pump .
- Remove bolts (1) and disconnect harness assembly (2) and remove the transmission oil pump. The weight of the transmission oil pump is approximately
36 kg (80 lb) .Show/hide table
Illustration 2 g03419779 - Reposition torque converter (3), as shown.
- Attach Tooling (A) and a suitable lifting device to torque converter (3).
Show/hide table
Illustration 3 g02160848 - Remove bolts (4).
Note: Note the lengths and locations of bolts (4).
- Remove torque converter (3) from transmission (5). The weight of torque converter (3) is approximately
222 kg (490 lb) .
| |
| Illustration 1 | g03419770 |
