966M Tier 4 and 972M Tier 4 Wheel Loaders Power Train Transmission to Output Transfer Gears - Connect Caterpillar

Connection Procedure

Note: Cleanliness is an important factor. Before assembly, all parts should be cleaned thoroughly in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.

Note: A CWS login is required to access AVSpare Channel1. Scan the QR code with a QR enabled device or copy the link that follows.

Illustration 1	g06428150

Reference: For more information, refer to "966 GC Wheel Loader Transmission from Output Transfer Gears – Connect" on AVSpare Channel1.

Show/hide table

Illustration 2	g03367344

1. Apply a continuous bead of Tooling (B) to the face of the transfer gears housing (6) before mating transmission (4) to the transfer gears housing (6).

2. Use Tooling (A) and a suitable lifting device to position transmission (4), as shown. The weight of transmission (3) is approximately 425 kg (936 lb).
   Show/hide table

   Illustration 3	g06535471

3. Apply Tooling (B) to both sides of the washers before installing onto bolts (5) and (6). Install bolts (5) that connect transmission (4) to transfer gears (6). Tighten bolts (5) to a torque of 120 ± 20 N·m (90± 15 lb ft).
   Show/hide table

   Illustration 4	g03367336

4. Connect harness assembly (3).
   Show/hide table

   Illustration 5	g03367331

5. Install tube assembly (2) and bolts (1).

End By:

1. Connect the torque converter to the transmission.