C9.3 Engines for Caterpillar Built Machines Flame Detection Temperature Sensor - Remove and Install Caterpillar


Flame Detection Temperature Sensor - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
Loctite 771 Anti-Seize Compound 


    Illustration 1g06117683

  1. Remove cable straps (1) and remove flame detection temperature sensor (2).


    Illustration 2g06117950

  2. Remove cable straps (4) and disconnect harness assembly (5).

  3. Remove the inlet temperature sensor (3), which is located on the diesel particulate filter.

Installation Procedure

  1. Install the flame detection temperature sensor in the reverse order.

    1. Apply Tooling (A) to the threads on flame detection temperature sensor (2) and to the threads of inlet temperature sensor (3). Tighten the flame detection temperature sensor (2) and the inlet temperature sensor (3) to a torque of 45 ± 5 N·m (33 ± 4 lb ft).

Information System:

3512B, 3512C, and 3516B Generator Set Engines with Dynamic Gas Blending Air Starting System
C13, C15, and C18 Tier 4 Interim Engines Sensor Supply - Test
C4.4 Industrial Engine Piston Height - Inspect
C3.4B Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
973D Track-Type Loader Power Train Brake and Final Drive Group
973D Track-Type Loader Power Train Tracks
953D, 963D and 973D Track-Type Loaders Brake Does Not Release
C9.3 Engines for Caterpillar Built Machines Nozzle Heater Harness - Remove and Install - Harness Assembly
953D, 963D and 973D Track-Type Loaders Backup Alarm Does Not Function
D7E Track-Type Tractor Hydraulic, HVAC, and Electrical Systems Hydraulic Fan Speed (On Demand) - Test and Adjust
2009/07/20 Improved Routing for the Ride Control Lines is Now Used {5004, 5057}
D7E Track-Type Tractor Hydraulic, HVAC, and Electrical Systems Piston Motor (Fan Drive)
Pivot Shaft Seal Leaks On D6K, D6N, And Track-Type Loaders{4153}
C9.3 Engines for Caterpillar Built Machines Temperature Sensor (DPF) - Remove and Install
2009/07/06 New AMOCS Seals That Are Between the Radiator Core and the Tank Are Now Available on Certain Track-Type Tractors and Pipelayers {1353}
3500 Engines Exhaust Elbow - Remove and Install
D8T Track-Type Tractor Declaration of Conformity
D10T Track-Type Tractor Declaration of Conformity
D9T Track-Type Tractor Declaration of Conformity
Installation of the Angling Blade Bulldozer on the D7E Track-Type Tractor{6050, 6701}
3500 Engines Exhaust Manifold - Remove and Install
953D, 963D and 973D Track-Type Loaders Hydraulic System Has Unusual Noise
C9.3 Engines for Caterpillar Built Machines Air Cleaner Housing - Remove and Install
D6T Track-Type Tractor Systems Pressure Reducing Valve - Test and Adjust