D3K, D4K and D5K Track-Type Tractors Machine Systems Hydraulic Control Support - Disassemble Caterpillar

Disassembly Procedure

Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. keep components covered and protected at all times.

Show/hide table

Illustration 1	g01358705

1. Remove covers (1).
   Show/hide table

   Illustration 2	g01358703

2. Remove bracket assemblies (2). Remove bolt (3). Remove screws (4).
   Show/hide table

   Illustration 3	g01358698

3. Remove screws (5). Remove screw (6). Remove cushion (8). Remove operator console (7).
   Show/hide table

   Illustration 4	g01358707

4. Remove cover (9).
   Show/hide table

   Illustration 5	g01358701

5. Remove brackets (10) and (11).
   Show/hide table

   Illustration 6	g01358702

6. Remove adjusting pin (13). Remove adjusting rods (12).
   Show/hide table

   Illustration 7	g01358700

7. Remove plate (14).
   Show/hide table

   Illustration 8	g01358711

8. Remove set screw (15).
   Show/hide table

   Illustration 9	g01358708

9. Remove pin (16).
   Show/hide table

   Illustration 10	g01358710

10. Remove spacers (17). Remove bearing (18).
    Show/hide table

    Illustration 11	g01358699

11. Remove plugs (19).
    Show/hide table

    Illustration 12	g01358706

12. Remove seals (20). Remove two sets of bearings (21).