Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects the following condition:
- Exhaust inlet temperature is greater than the default temperature of
600 °C (1112 °F) for five seconds. - The engine has been running for three seconds.
- The diagnostic codes CID-FMI 827-08 and CID-FMI 828-08 are not active.
System Response:
The event is logged. The warning is active when the exhaust inlet temperature is above
Possible Performance Effect:
- None
Troubleshooting:
- There may be an exhaust restriction above recommended levels.
- There may be a problem with the cooling system.
- There may be a problem with the coolant temperature sensor.
Test Step 1. Check for "ACTIVE" Diagnostic Codes.
- Start the AVSpare Electronic Technician (ET).
- Turn the main power to the ON position.
- Check for any active diagnostic codes or logged diagnostic codes.
Expected Result:
No diagnostic codes are present.
Results:
- OK - No diagnostic codes are present. Proceed to Test Step 2.
- Not OK - Diagnostic codes are present.
Repair: Repair the diagnostic codes that are present. Refer to the appropriate topic in the "Troubleshooting With a Diagnostic Code" section of this manual. Ensure that the repair eliminates the problem.
STOP
Test Step 2. Perform a Check of the Cooling System.
- Perform a check of the cooling system. Refer to the diagnostic procedure Troubleshooting, "Coolant Temperature is Too High" for possible causes.
Expected Result:
There are no problems with the cooling system.
Results:
- OK - There may be an intermittent problem.
Repair: Monitor the operation of the engine. Repair the problem. Ensure that the repair eliminates the problem.
STOP
- Not OK - There is a problem with the cooling system.
Repair: Repair the problem. Ensure that the repair eliminates the problem.
STOP