Electrical Connectors
`
C9.3 Engine for Wheel Tractor-Scrapers
[KENR9242]
ELECTRICAL AND STARTING SYSTEM
WIRING GP
C9.3 Engine for Wheel Tractor-Scrapers
Electrical Connectors
C9.3 Engines for Caterpillar Built Machines
Electrical Connectors - Inspect
C13, C15, and C18 Tier 4 Interim Engines
ARD Ignition - Test
1.1. Connectors for the Electronic Control Module (ECM)
2.1. Injector Connectors
3.2. Connectors at the Valve Cover
4.2. Connector at the Injector
5.1. Sensor Connectors
6.2. Analog Sensor Connector (active)
7.2. Analog Sensor Connector (passive)
8.2. Connectors for the Termination Resistor
9.2. Engine Speed/Timing Connector
10.2. Ampseal Connector (typical)
11.2. Deutsch Connectors (typical)
Connectors for the Electronic Control Module (ECM)
Show/hide table
![]() | |
Illustration 1 | g02141017 |
Locations of the components at the ECM (1) P2 ECM connector (ECM side) (2) P1 ECM connector (ECM side) (3) P2 ECM connector (harness side) (4) P1 ECM connector (harness side) (5) ECM |
Injector Connectors
Connectors at the Valve Cover
Show/hide table
![]() | |
Illustration 2 | g01746753 |
Connector at the Injector
Show/hide table
![]() | |
Illustration 3 | g01717773 |
Typical injector |
Sensor Connectors
Analog Sensor Connector (active)
Show/hide table
![]() | |
Illustration 4 | g01240891 |
Analog Sensor Connector (passive)
Show/hide table
![]() | |
Illustration 5 | g01241538 |
Connectors for the Termination Resistor
Show/hide table
![]() | |
Illustration 6 | g01355248 |
Engine Speed/Timing Connector
Show/hide table
![]() | |
Illustration 7 | g01155187 |
Ampseal Connector (typical)
Show/hide table
![]() | |
Illustration 8 | g02219254 |
Refer to Special Instruction, REHS2556 for additional information |
Deutsch Connectors (typical)
Show/hide table
![]() | |
Illustration 9 | g02220494 |
Refer to Tool Operating Manual, SEHS9615, "Servicing Deutsch HD and DT Style Connectors" for additional information |
Information System:
D5R Track-Type Tractor
Hydraulic System Has Unusual Noise
C15 and C18 Industrial Engines
Temperature Sensor (DPF) - Remove and Install - Clean Emissions Module
980H Wheel Loader Power Train
Transmission Planetary - Disassemble - Heavy Duty
D5R Track-Type Tractor
MID 039 - CID 2671 - FMI 06
D7E Track-Type Tractor Power Train
Track Adjuster - Assemble
D7E Track-Type Tractor Power Train
Track Adjuster - Disassemble
D7E Track-Type Tractor Power Train
Recoil Cylinder - Assemble
D7E Track-Type Tractor Power Train
Recoil Cylinder - Disassemble
Inspection of Slag Buckets{6110}
D5R Track-Type Tractor
Connector Locations
Rework of the Blade Assembly{6060}
973D Track-Type Loader Hydraulic System
Hydraulic Tank and Filter
D5R Track-Type Tractor
Hydraulic System Oil Contains Air
C11, C13, C15, and C18 Industrial Engines
ECM - Replace
2009/04/27
Proper Long Term Storage of Caterpillar Products {0355, 1000, 7000}
3500B and 3500C Marine Engines
Alternator and Regulator
Relocation of the Rear Disconnect Switch {1411}
2009/07/27
A New Fuel Line Is Now Used on D9T Track-Type Tractors {1274}
2009/04/27
Preferred Positions for Mechanically Attached Wear Plates (MAWPS) {6100, 6120, 6820}
Installation of VIMS Guardian on Underground Mining Machines{7601}
C15 and C18 Industrial Engines
Flame Detection Temperature Sensor - Remove and Install - Clean Emissions Module
A New Flange Assembly For the Torque Converter On the D10T Is Now Used{3101}
C13 Tier 4 Final Engines
Lubrication System
2009/05/04
A Repair Kit for the Magnet is Now Available for the AccuGrade CD700 Display {7490}