![]() | |
Illustration 1 | g01885859 |
Machine ECM (1) J1 Connector (2) J2 Connector (3) Machine ECM (4) Front Cab Window |
The machine ECM is mounted to the firewall below the front cab window.
![]() | |
Illustration 2 | g02952816 |
(5) Operator Seat (6) Electrical Panel |
![]() | |
Illustration 3 | g02952817 |
(7) ET service connector |
The ET Service Connector (7) is located on the LH side of the cab, next to the operator seat, behind the (6) Electrical panel cover. Remove the cover to access the connector.
The Electrical System Schematic, Parts Manual, and Operation and Maintenance Manual for the machine that is being serviced should be used to locate electrical components and connectors.
The following information is a guide to reading the tables on the back of the Electrical System Schematic.
- The "Component Location" table uses white circles to mark the locations in the profile of the machine and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the machine. Refer to the corresponding footnote at the end of the table for a description of the location.
- The "Harness Connector Location" table uses white circles to mark the locations in the general view and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the machine. Refer to the corresponding footnote at the end of the table for a description of the location.
Connector Contact Numbers
![]() | |
Illustration 4 | g01341037 |
Electronic Control Module (ECM) |
![]() | |
Illustration 5 | g01341038 |
Back View of Machine Harness Connectors J1 and J2 that mate to the ECM. |