D6T Track-Type Tractor Hydraulic System Pressure Taps Caterpillar


Pressure Taps
`
1.1. Locations of the Pressure Taps for the Implement Section
2.1. Location of the Pressure taps for the Steering Section


NOTICE

Do not connect or disconnect hose fittings to or from the quick disconnect nipples when there is pressure in the system. This will prevent damage to the seals that are in the fitting.


Locations of the Pressure Taps for the Implement Section




Illustration 1g02946976

The pressure taps are located behind an access door on the right fender of the operator station.

(CP) Pilot supply pressure

(HA) Discharge pressure of the Implement pump

(SOS) Implement hydraulics (Scheduled oil sampling)

(CPG) Accumulator pressure

(HB) Signal pressure for the Implement pump at the compensator valve

Location of the Pressure taps for the Steering Section




Illustration 2g02352685

The pressure tap is located behind an access door on the left fender of the operator station.

(H) Pressure tap for the steering charge filter




Illustration 3g02061913

The pressure taps are located on top of the steering motor.

(HC) Pressure tap for the steering motor

(HD) Pressure tap for the steering motor

Information System:

C13 Engines for Caterpillar Built Machines Diesel Particulate Filter - Remove and Install - Clean Emissions Module
C13 Engines for Caterpillar Built Machines Flame Detection Temperature Sensor - Remove and Install - Clean Emissions Module
D5R Track-Type Tractor Power Train Track Roller Frame
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Push Arms and Blade - Install
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Push Arms and Blade - Remove
C13 Engines for Caterpillar Built Machines Pressure Sensor (DPF) - Remove and Install - Differential Pressure, Clean Emissions Module
2009/06/29 New Hardware is Available for Certain Wheel Tractor-Scrapers Draft Frames {6204, 7000, 7960}
C15 and C18 Industrial Engines Nozzle Heater Harness - Remove and Install
C13 Engines for Caterpillar Built Machines Fuel Manifold (ARD) - Remove and Install - Clean Emissions Module
C13 Engines for Caterpillar Built Machines Air Control Valve - Remove and Install - ARD Combustion, Clean Emissions Module
Procedure to Align the Dial on the Fuel Sender{1273, 7481, 7857}
D7E Track-Type Tractor Power Train Track Roller Frame - Remove and Install
C13 Engines for Caterpillar Built Machines Catalyst - Remove and Install - Diesel Oxidation Catalyst, Clean Emissions Module
Installation and Removal of the V-PAT Bulldozer{6050, 6079}
C13 Engines for Caterpillar Built Machines Temperature Sensor (DPF) - Remove and Install - Clean Emissions Module
Oversized Injector Sleeves for Remanufactured Cylinder Heads On Medium Sized Engines{1100, 1101, 1125}
Installation of Ripper (3TP){6310}
2009/10/29 A New Bowl for the Fuel/Water Separator Is Used {1261, 1263}
Improved Method for Installing the Actual Gear Position Sensor {1439, 3061}
2009/05/04 Improved Installation Procedure for the Heater Cable {7304}
C9.3 Engines for Caterpillar Built Machines Exhaust Manifold - Remove and Install
C13 Engines for Caterpillar Built Machines Muffler - Remove and Install - Clean Emissions Module
C13, C15, and C18 Tier 4 Interim Engines Injector Solenoid - Test
C9.3 Engines for Caterpillar Built Machines Fuel Injection Pump - Test