| |
| Illustration 1 | g03684264 |
Hydraulic oil cooler is located at the right front of the machine with the radiator.
Reference: Refer to Systems Operation, UENR4089, "Hydraulic Oil Cooler" for additional information.
| |
| Illustration 2 | g03684274 |
Hydraulic implement pump is mounted behind the power train.
Reference: Refer to Systems Operation, UENR4089, "Piston Pump (Implement)" for additional information.
| |
| Illustration 3 | g03684360 |
The hydraulic oil filter is located inside the rear right-hand enclosure.
Reference: Refer to Systems Operation, UENR4089, "Hydraulic Oil Filter" for additional information.
| |
| Illustration 4 | g06582124 |
The bank valve is located in the middle of the machine under the operator seat.
Reference: Refer to Systems Operation, UENR4089, "Bank Valve (Implement)" for additional information about each individual valve section.
| |
| Illustration 5 | g03687923 |
The drift reduction valve is located behind the rear right panel.
Reference: Refer to Systems Operation, UENR4089, "Drift Reduction Valve (Ripper)" for additional information.
Reference: Refer to the Operation and Maintenance Manual, SEBU9226 for more information on the following controls
- Implement lift and tilt controls
- Blade angle thumb wheel
- Increment/power pitch extend switch
- Decrement/power pitch retract switch
- Blade shake and auto/manual switch
- Implement lockout switch
| |
| Illustration 6 | g03687932 |
The electronic control module is located on the machine right side, in the rear access panel.
Reference: Refer to Systems Operation, UENR4089, "Electronic Control (Hydraulic System)" for additional information.
| |
| Illustration 7 | g03687937 |
The diverter valve is located in the middle of the machine on the right-hand side.