for Dozing, Gen 3.0 Remote Control Operator Console with RFID Electrical Output Components Caterpillar

Remote Control Electrical Center

Illustration 1	g02450396
Cover has been removed for clarity

The Remote Control Electrical Center utilizes 16 relays. The relays are shown in Illustration 1. Each relay is controlled via a sinking driver of the System Master (RCM). The RCM controls the 24 VDC relays.

The Remote Control Electrical Center is located on the right side of the cab beneath the dash console.

Illustration 2	g03795837

24 VDC Relays

Illustration 3	g03408635

The 16 Relays control the machine functions that are listed here:

• Fire Suppression

• Horn

• Parking Brake Switch Disable

• Implement Lockout Bypass

• RC Auxiliary

• Cylinder Lights

• Ripper Light

• Camera Wash

• Forward ROPS Lights 1

• Fender/ Forward ROPS Lights 2

• Mode Select

• Machine Power

• Cab Key Disable

• Engine Start

• Rear ROPS Lights 1

• Rear ROPS Lights 2

The Remote Control ECM uses a 24VDC signal via a sinking driver of the remote control ECM to energize these relays. Refer to the Systems Operation section for detailed information on relay functions.