 | |
| Illustration 1 | g00102562 |
(1) Torque for final installation of the nut ... 14 ± 1.5 N·m (10 ± 1 lb ft)
(2) Torque for installing the nipple assembly ... 14 ± 4 N·m (10 ± 3 lb ft)
 | |
| Illustration 2 | g00102561 |
(3) Torque for installing the cartridge assembly ... 50 ± 5 N·m (37 ± 4 lb ft)
(4) Lubricate the O-ring with a minimal amount of the lubricant that is being sealed.
(5) Torque for installing the seat ... 19 ± 4 N·m (14 ± 3 lb ft)
(6) Lubricate the O-ring with a minimal amount of the lubricant that is being sealed.
(7) Torque for installing the orifice ... 2 ± 1 N·m (18 ± 9 lb in)
(8) 118-3731 Spring
- Length under test force ... 14.00 mm (.551 inch)
- Test force ... 36.0 ± 1.8 N (8.10 ± .40 lb)
- Free length after test ... 15.99 mm (.630 inch)
- Outside diameter ... 12.1 mm (.48 inch)
- Test force ... 36.0 ± 1.8 N (8.10 ± .40 lb)
Flow of SAE 30W oil at 1000 kPa (145 psi) pressure drop ... 65 L/min (17 US gpm)
Nominal coil voltage ... 12 VDC
Maximum coil voltage ... 14.5 VDC
Minimum coil voltage ... 10.7 VDC
Nominal coil resistance at 25°C (77°F) ... 7.75 ± 1.00 Ohms
Maximum coil resistance at 121°C (220°F) ... 12.68 Ohms
Minimum coil resistance at -40°C (-40°F) ... 5.81 Ohms
Nominal current draw at 25°C (77°F) ... 1.55 Amperes
Maximum current draw at -40°C (-40°F) ... 2.5 Amperes