Turbocharger
`
3500 Engines
[RENR9362]
AIR INLET AND EXHAUST SYSTEM
TURBOCHARGER GP
Show/hide table
| |
| Illustration 1 | g02849399 |
Show/hide table
| Specification for 261-7279 Turbocharger Gp | |||
| Item | Qty | Part | Specification Description |
| 1 | 8 | 2N-2766 Locknut | Torque to |
| 2 | 8 | 2N-2765 High Temperature Bolt | Before assembly, lubricate the threads and the bearing surfaces with Loctite C5A Copper Anti-Seize. |
Show/hide table
| |
| Illustration 2 | g02849400 |
Show/hide table
| Specification for 261-7279 Turbocharger Gp | |||
| Item | Qty | Part | Specification Description |
| 3 | 2 | 6L-3005 Band Clamp | Use the following procedure in order to tighten the clamps:
1. Tighten clamps to 2. Gently tap around the clamps with a soft faced hammer. 3. Again, tighten clamps to |
| 4 | 2 | 9N-2038 Turbine Clamp As | Use the following procedure in order to tighten the clamp assemblies:
1. Tighten clamp assemblies to 2. Gently tap around the clamp assemblies with a soft faced hammer. 3. Again, tighten the clamp assemblies to |
| 5 | 2 | 4W-9977 Clamp As | |
Information System:
D6T Track-Type Tractor Systems
Accumulator (Pilot) - Test and Charge
2009/05/04
A Tilt Regeneration Kit Is Now Available for the 988G and 988H Machines {1408, 5057, 5104, 512R}
D6T Track-Type Tractor Systems
Piston Pump (Implement) - Test and Adjust
D6T Track-Type Tractor Hydraulic System
Operational Checks
C9.3 Engines for Caterpillar Built Machines
Fuel Injection Pump - Test
C13, C15, and C18 Tier 4 Interim Engines
Injector Solenoid - Test
C13 Engines for Caterpillar Built Machines
Muffler - Remove and Install - Clean Emissions Module
C9.3 Engines for Caterpillar Built Machines
Exhaust Manifold - Remove and Install
2009/05/04
Improved Installation Procedure for the Heater Cable {7304}
Improved Method for Installing the Actual Gear Position Sensor {1439, 3061}
2009/10/29
A New Bowl for the Fuel/Water Separator Is Used {1261, 1263}
Installation of Ripper (3TP){6310}
3500 Engines
Air Inlet and Exhaust Lines
3500 Engines
Air Lines
C4.4 Industrial Engine
Air in Fuel - Test
C7.1 Industrial Engine
Fuel Injection Timing - Check
C4.4 Industrial Engine
Compression - Test
C4.4 Industrial Engine
Valve Depth - Inspect
C4.4 Industrial Engine
Cooling System Coolant Level - Check
C7.1 Industrial Engine
Engine Oil Cooler - Inspect
C7.1 Industrial Engine
Connecting Rod - Inspect
C7.1 Industrial Engine
Cylinder Head - Inspect
C4.4 Industrial Engine
Flywheel - Inspect
C7.1 Engines for Caterpillar Built Machines
Vibration Damper - Check