Fast Fill Hose Inspection On Certain D8TTrack-Type Tractors Equipped With a Fast Fuel Attachment{1273, 1710} Caterpillar


`
Fast Fill Hose Inspection On Certain D8TTrack-Type Tractors Equipped With a Fast Fuel Attachment{1273, 1710} [TIBU7749]
FUEL SYSTEM
TANK GP-FUEL
1.1. Introduction
2.1. Problem
3.1. Solution
Track-Type Tractor:
D8T (S/N: FCT1-1533)

Introduction

The problem that is identified below does not have a known permanent solution. Use the solution below.

Problem

This TIB should be applied when a low fuel pressure has been identified. Apply this procedure after regular troubleshooting has been completed if no resolution has been identified.

Certain D8TTrack-Type Tractors equipped with a fast fill fuel attachment may have low fuel pressure. The 193-5768 Hose As connecting the vent assembly to the fast fill fuel fill port has a label installed that may come loose. The adhesive on the label may fail letting the label fall inside the fuel tank. The label will cause a fuel restriction indicated by low fuel pressure codes.

Solution




Illustration 1g03718363

(A) 193-5768 Hose As

(B) Fast fill fuel fill port

(C) Fast fill fuel vent Vent




Illustration 2g03718412

(A) 193-5768 Hose As Label

Remove fast fill fuel vent (C). Inspect 193-5768 Hose As (A) to see if the identification label is still attached to the hose. If the identification label is still attached to hose assembly (A), remove the label and attach a metal tag.

If the identification label is not on the hose, drain the fuel tank and check for the label. Check inside the tank for the label as required. A bore scope may be required to inspect the inside of the tank.

Information System:

C280 Marine Engines Secondary ECM Assumes Control
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Engine Control Switch - Test
3516B Generator Set Engines with Dynamic Gas Blending Intake Manifold Air Temperature Is High
950M and 962M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Steering Control Valve
D7E Track-Type Tractor Engine Oil and Filter - Change
950 GC Wheel Loader Power Train Trunnion Support (Oscillating Axle, Rear) - Remove and Install
3516B Generator Set Engines with Dynamic Gas Blending Camshaft Timing
950M and 962M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Transfer Gear Bearing Preload - Adjust
2014/12/19 The AccuGrade Blade Angle Sensor Bracket Has Been Relocated and Has a New Designed Cover On Certain D6K2 and D6N Track-Type Tractors {6052, 6060, 6701}
950 GC Wheel Loader Power Train Fixed Axle (Front) - Remove and Install
525D, 535D, 545D, 555D Wheel Skidder Engine Operation
C3.4B Engines DEF Line Heater - Test
D7E Track-Type Tractor Systems Electronic Control (Power Train System)
2014/10/16 New Ejector Cylinder Group is Now Used on Certain 631G and 637G Wheel Tractor-Scrapers {5305}
D4, D6K2 and D6K Track-Type Tractor Systems Electronic Control (Hydraulic System)
C175-16 Locomotive Engine Configuration Parameters
980L Medium Wheel Loader Power Train, Steering, Braking, Hydraulic, and Machine Systems Transmission Speed for Forward Directional Shift - Program
980L Medium Wheel Loader Power Train, Steering, Braking, Hydraulic, and Machine Systems Transmission Speed for Reverse Directional Shift - Program
950 GC Wheel Loader Power Train Trunnion Support (Oscillating Axle, Front) - Remove and Install
3512E Petroleum Engines Engine Governing - Adjust
Relocation Procedure of the Engine Outlet NOx Sensor On Certain 834K, 836K, and 988K Machines{7490}
2014/10/23 Improved Woodchip Screens are now used on D8T Track-Type Tractors Equipped with Quick Release Radiator Grills {7170}
986H Wheel Loader Differential and Bevel Gear - Disassemble
Instrument Display Turn Signal Indicators Do Not Blink When the Signal Switch is Activated{1430}