PRODUCT SUPPORT PROGRAM FOR REPLACING SOFTWARE ON CERTAIN C175-16 LOCOMOTIVE ENGINES Caterpillar


`
PRODUCT SUPPORT PROGRAM FOR REPLACING SOFTWARE ON CERTAIN C175-16 LOCOMOTIVE ENGINES [UEBE1322]
ELECTRICAL AND STARTING SYSTEM
ELECTRONICS GP-ENGINE
PRODUCT SUPPORT PROGRAM FOR REPLACING SOFTWARE ON CERTAIN C175-16 LOCOMOTIVE ENGINES
UEBE1322-00

12Oct2020


U-602
O-556

 

Before/After

  
  

PRODUCT SUPPORT PROGRAM FOR REPLACING SOFTWARE ON CERTAIN C175-16 LOCOMOTIVE ENGINES

1920
PS46885
NOTE:

AVSpare’s obligations under this Service Letter are subject to, and shall not apply in contravention of, the laws, rules, regulations, directives, ordinances, orders, or statutes of the United States, or of any other applicable jurisdiction, without recourse or liability with respect to AVSpare.

NOTE:

This Program must be administered either before or after failure. In either case the decision whether to apply the Program is made by the dealer. When reporting the repair, use "PS46885" as the Part Number and "7755" as the Group Number. If administered before failure, use "56" as the Warranty Claim Description Code and "T" as the SIMS Description code. If administered after failure, use "96" as the Warranty Claim Description Code, and "Z" as the SIMS Description Code.

NOTE:

The information supplied in this service letter may not be valid after the termination date of this program. Do not perform the work outlined in this Service Letter after the termination date without first contacting your AVSpare product analyst.


TERMINATION DATE

31Oct2022

PROBLEM

The existing software does not notify the unit if a significant exhaust leak is present on certain C175-16 Locomotive Engines. If the existing exhaust system has a significant leak it can/will result in engine and locomotive damage.

AFFECTED PRODUCT

Model Identification Number
C175-16  3B900100-00164, 1000

PARTS NEEDED

Qty

Part Number Description
1 6036577 Aftertreatment Software
1 6058676 Engine Software
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 32% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.


ACTION REQUIRED

Flash the engine ECM with 6058676 Software and the aftertreatment ECM with 6036577 Software or latest available in SIS Web. To enable the exhaust leak detection the SCR Inlet Pressure Low Level 3 event must be turned "On" in the monitoring system.

SERVICE CLAIM ALLOWANCES

Product smu/age whichever comes first
AVSpare
Dealer Suggested
Customer Suggested
Parts %
Labor Hrs%
Parts %
Labor Hrs%
Parts %
Labor Hrs%
0-24000 hrs,
0-12 mo 
100.0%
100.0%
0.0%
0.0%
0.0%
0.0%
 NOTE: This is a 1.0-hour job



PARTS DISPOSITION

Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
 
 
 

Information System:

PRODUCT SUPPORT PROGRAM FOR REPLACING HOSE ASSEMBLIES ON CERTAIN D5 AND D6 TRACK-TYPE TRACTORS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE DEF PUMP ON CERTAIN CATERPILLAR PRODUCTS EQUIPPED WITH A C7.1 ENGINE
PRODUCT SUPPORT PROGRAM FOR UT INSPECTION AND/OR REPLACING THE WHEEL AND FINAL DRIVE GROUP ON CERTAIN 980M WHEEL LOADERS
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND REMOVING CERTAIN SUN GEARS FROM DEALER PARTS STOCK
PRODUCT SUPPORT PROGRAM FOR REPLACING THE NRS COOLER ON ON CERTAIN 336F, 340F AND 352F EXCAVATORS, 725, 730 AND 735 ARTICULATED TRUCKS, 772G OFF-HIGHWAY TRUCKS, 826K LANDFILL COMPACTORS, 966, 972 AND 980 WHEEL LOADERS, D6T TRACK-TYPE TRACTORS, AND P
PRODUCT SUPPORT PROGRAM FOR REWORK OF THE 508-1607 FUEL TANK GROUP (FAST FILL) AND 508-1611 FUEL TANK GROUP (STANDARD) ON CERTAIN D5 XL AND LGP TRACK-TYPE TRACTORS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE SHORT BLOCK ON CERTAIN D11T TRACK-TYPE TRACTORS THAT HAVE BEEN REPAIRED OR REPLACED WITH A REMAN C32 SHORT BLOCK (20R0195, 20R2866, 20R6928), LONG BLOCK (20R6342), OR ENGINE (10R8902, 20R2506, 20R2507)
PRODUCT SUPPORT PROGRAM FOR REPLACING THE PRODUCT LINK RADIO ON CERTAIN CATERPILLAR PRODUCTS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE TRANSMISSION HARNESS ASSEMBLY ON CERTAIN 972M XE MEDIUM WHEEL LOADERS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE STEERING CASE DRAIN OIL FILTER SWITCH ON CERTAIN D5 TRACK-TYPE TRACTORS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE TELESCOPING CYLINDER ON CERTAIN TH357D TELEHANDLERS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE DIFFERENTIAL LOCK SYSTEM ON CERTAIN 627H AND 627K WHEEL TRACTOR-SCRAPERS
PRODUCT SUPPORT PROGRAM FOR UPDATING THE SEAT HARNESS ON CERTAIN 953K, 963K, AND 973K TRACK-TYPE LOADERS
PRODUCT SUPPORT PROGRAM FOR REWORKING THE CHASSIS WIRING HARNESS ON CERTAIN D8T TRACK-TYPE TRACTORS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE HYDRAULIC TILT CYLINDER ON CERTAIN 910K, 914K, 920K, 910M, 914M, AND 918M COMPACT WHEEL LOADERS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE HYDRAULIC LIFT CYLINDER ON CERTAIN 910K, 914K, 920K, 910M, 914M, AND 918M COMPACT WHEEL LOADERS
PRODUCT IMPROVEMENT PROGRAM FOR INSTALLING SOFTWARE ON CERTAIN 938K AND 938M SMALL WHEEL LOADERS
PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING, LABELING, AND REWORKING THE 580-8500-00 HARNESS THAT IS PART OF 580-8498-00 SERVICE AND MAINTENANCE (SAM) HARNESS TOOLING GROUP IN DEALER TOOL INVENTORY
PRODUCT SUPPORT PROGRAM FOR REPAIRING THE LIFT CYLINDER DUE TO LOOSE ROD/PISTON LOCKNUT ON CERTAIN D10T2 TRACK-TYPE TRACTORS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE 132-5125 WATER ELBOW ON CERTAIN D9R TRACK-TYPE TRACTORS
PRODUCT SUPPORT PROGRAM FOR REPLACING THE LINKAGE PIN RETAINERS ON CERTAIN 966M AND 980M MEDIUM WHEEL LOADERS
PRODUCT IMPROVEMENT PROGRAM FOR TESTING AND ADJUSTING THE LOAD CHECK VALVES ON CERTAIN 924K, 930K, 938K, 926M, 930M, AND 938M SMALL WHEEL LOADERS
PRODUCT SUPPORT PROGRAM FOR REPLACING PRODUCT LINK PL121, PL321, PL542 SATELITE RADIOS ON CERTAIN CATERPILLAR PRODUCTS
PRODUCT IMPROVEMENT PROGRAM FOR REMOVING CERTAIN 9U-7763 PULLER STUDS FROM DEALER TOOL INVENTORY AND CUSTOMER TOOL INVENTORY, AND DEALER AND CUSTOMER SERVICE FACILITIES