Installing Tool Bar Beam Assembly
Put 18 inch (45 cm) blocks under beam assembly
Back tractor up to beam
Align brackets with draft members
Install pins and cotter (two on each side)
Locating Draft Members
2-3 inches (50-75 mm) clearance on each side
Loosen bracket bolts
Move brackets
For correct clearance
Tighten bolts
Beam Adjustment
Beam must be parallel to ground when implement is at desired penetration depth
Lengthen screws to decrease penetration
NOTE: Do not lengthen screw more than 5 1/2 inches (140 mm)
Shorten screws to increase penetration
Lock handles
Removing Tool Bar Beam Assembly
Put 18 inch (45 cm) blocks under beam assembly
Remove adjusting screw cotter and pin (one on each side)
Remove draft member cotter and pin (one on each side)
Drive tractor away
Installing Tool Bar Blade
Remove tool bar beam assembly and drive tractor ahead
Swing draft frame arms to the front
Attach diagonal braces to eyebolt on blade with pins and cotters
With blade in vertical position and stand installed
Drive tractor into position and install draft frame pins and cotters
Install adjusting screw pins and cotters
Attach diagonal braces to draft frame arms with pins and cotters
Raise blade support stand
Adjusting Blade
To tilt blade:
Shorten screw on side to be low
Lengthen screw on side to be high
NOTE: Toolbar - Do not lengthen screw more than 5 1/2 inches (140 mm)
Bulldozer - Do not lengthen screw more than 5 inches (127 mm)
To tip blade:
Shorten both adjusting screws to tip blade back
Lengthen both adjusting screws to tip blade forward
NOTE: Toolbar - Do not lengthen screw more than 5 1/2 inches (140 mm)
Bulldozer - Do not lengthen screw more than 5 inches (127 mm)
Removing Blade
Lower support stand and blade
Remove diagonal braces
Remove cotters and pins from adjusting screws and draft frame
Back tractor away
DO NOT leave blade standing upright unless adequately supported
Reversing Fan Blades
Disconnect switch OFF
Push blade in
Twist blade to reverse notch
Reverse ALL blades
Reversing Hitch
Remove pin latches
Remove clevis
Remove plate
Position spacers (D4 only)
Install plate (face side stamped "B" toward bracket faces)
Install clevis
Install pin latches
| NOTICE |
|---|
Drawbar parts are heavy - handle with care |
General
Before Moving
Check gauges
Check tractor controls
Check implement controls
Check implement
Check hitch pin latches
Move obstructions
Raise equipment
Clear area
| NOTICE |
|---|
Do not cross power cables without ramp... |
Implements
Proper depth
Lift to turn
Good condition and alignment
Follow instructions
Night Operation
Adequate light
Inspect frequently
Stay alert
Watch for strays
Summary Of Operating Hints
- All gauges must read in normal operating range.
- All controls must work properly.
- All hose connections must be tight.
- Implement bolts, nuts and other connections must be tight
- Hitch pin lock must be engaged.
- Move all obstructions.
- Raise implements.
- Clear area of people.
- All controls must work properly.
- Shut down machine if any gauge shows abnormal reading.
- Stop machine if any control does not work properly.
- Keep implement at proper depth in ground.
- Lift implement before making sharp turn.
- Repair or replace implement when worn or damaged.
- Follow implement manufacturers instructions.
- Stop machine if any control does not work properly.
- Operate only with adequate light.
- Inspect machine and implement frequently.
- Stay alert. If drowsy, stop machine and stretch or walk around machine. Drink some coffee.
- Keep a sharp lookout for stray animals.
- Inspect machine and implement frequently.