953C Track-Type Loader Circuit Breakers and Fuses - Reset/Replace Caterpillar


Circuit Breakers and Fuses - Reset/Replace
`
953C Track-Type Loader [SEBU7495]
ELECTRICAL AND STARTING SYSTEM
953C Track-Type Loader Circuit Breakers and Fuses - Reset/Replace
1.1. Reset Circuit Breakers
2.1. Replace Fuses

Reset Circuit Breakers



Illustration 1g00953407

The circuit breakers are located behind the console panel on the left side of the machine.



Illustration 2g00960192

Circuit Breaker Reset - Push in the button in order to reset the circuit breaker. If the electrical system is working properly, the button will remain depressed. If the button does not remain depressed, check the appropriate electrical circuit. Repair the electrical circuit, if necessary.

Replace Fuses



Illustration 3g00954503

The fuses are located inside the left hand console cover. Remove the two clips in order to remove the cover.

Fuses - Fuses protect the electrical system from damage that is caused by overloaded electrical circuits. Replace a fuse if the element separates. If the fuse of a particular electrical system requires frequent replacement, check the electrical circuit. Repair the electrical circuit, if necessary.


NOTICE

Always replace fuses with the same type and capacity fuse that was removed. Otherwise, electrical damage could result.



NOTICE

If it is necessary to replace fuses frequently, an electrical problem may exist.

Contact your AVSpare dealer.




Illustration 4g00954489

Spare (1) - 15 Amp

Spare (2) - 10 Amp

Spare (3) - 15 Amp

Spare (4) - 10 Amp

Front and Rear Windshield Wiper/Washer (5) - 15 Amp

Electronic Monitoring System (6) - 10 Amp

Transmission (7) - 10 Amp

Spare (8) - 15 Amp

Air Conditioner (9) - 20 Amp

Bucket (10) - 10 Amp

Seat (11) - 15 Amp

Beacon (12) - 10 Amp

Horn (13) - 10 Amp

Note: The dome lamp and the display backlight on the monitoring system also use this fuse.

Electronic Fuel Injection (14) - 15 Amp

Flood Lamp Group (15) - 15 Amp

MSS and Product Link (16) - 10 Amp

Note: The machine security system and the product link also use this fuse.

12 Volt Power Terminal (17) - 15 Amp

Note: The power converter and the radio also use this fuse.

Key Start Switch (18) - 10 Amp

Spare (19) - 115 Amp

Spare (20) - 10 Amp

Information System:

953C Track-Type Loader Lubricant Viscosities
TH220B, TH330B and TH340B Telehandlers Machine Systems Transmission
966H and 972H Wheel Loaders Differential and Final Drive Oil Sample - Obtain
966G II and 972G II Wheel Loaders Differential and Final Drive Oil - Change
3044C Industrial Engine and Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
953C Track-Type Loader Operation Information
966G II and 972G II Wheel Loaders Cooling System Coolant Sample (Level 1) - Obtain
953C Track-Type Loader Monitoring System
953C Track-Type Loader Sound Information and Vibration Information
TH210 and TH215 Telehandlers Cooling System Coolant Extender (ELC) - Add
3044C Industrial Engine and Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
966G II and 972G II Wheel Loaders Work Tool Positioner
953C Track-Type Loader Hydrostatic Transmission and Hydraulic System Oil Sample - Obtain
3500B Series II Marine Engines System Overview
3516B Generator Set Engines with Dynamic Gas Blending Electronic Display Module
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Engine Does Not Start and Status Indicator Is Continuously Red (MSS)
D6R Series II Track-Type Tractor Transmission System Oil - Change
3044C Industrial Engine and Engines for Caterpillar Built Machines Engine Oil Pump - Remove
TH220B, TH330B and TH340B Telehandlers Hydraulic System Hydraulic System Pressure - Release
TH220B, TH330B and TH340B Telehandlers Axle Breathers - Clean/Replace
3500B Series II Marine Engines Engine Monitoring System
953C Track-Type Loader Operator Controls
953C Track-Type Loader Engine Starting
953C Track-Type Loader Lift Kickout