963C Track-Type Loader Coolant Sample (Level 1) - Obtain - Diesel Engine Antifreeze/Coolant (DEAC) Caterpillar


Coolant Sample (Level 1) - Obtain - Diesel Engine Antifreeze/Coolant (DEAC)
`

Testing the engine coolant is important to ensure that the engine is protected from internal cavitation and from corrosion. The analysis also tests the ability of the coolant to protect the engine from boiling and from freezing. The S·O·S Coolant Analysis can be done at your AVSpare dealer. AVSpare S·O·S Coolant Analysis is the best way to monitor the condition of your coolant and your cooling system. S·O·S Coolant Analysis is a program that is based on periodic samples.


NOTICE

Always use a designated pump for oil sampling, and use a separate designated pump for coolant sampling. Using the same pump for both types of samples may contaminate the samples that are being drawn. This contaminate may cause a false analysis and an incorrect interpretation that could lead to concerns by both dealers and customers.




Illustration 1g00274749
The cooling system pressure cap is in the hood at the right rear of the machine.

------ WARNING! ------

Personal injury can result from hot coolant, steam and alkali.

At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.

Remove filler cap slowly to relieve pressure only when engine is stopped and radiator cap is cool enough to touch with your bare hand.

Cooling System Conditioner contains alkali. Avoid contact with skin and eyes.


Remove the cooling system pressure cap slowly in order to relieve pressure on the system.

Use a 1U-5718 Vacuum Pump or an equivalent pump. Insert the pump into the filler pipe in order to obtain an S·O·S sample of the coolant.

Maintain the coolant level at 13 mm (0.5 inch) from the bottom of the filler pipe.

Install the cooling system pressure cap.

Information System:

950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Power Train Transmission Planetary - Disassemble
963C Track-Type Loader Capacities (Refill)
963C Track-Type Loader Engine Starting
TH220B, TH330B and TH340B Telehandlers Hydraulic System General Information Table
988G Wheel Loader Cooling System Coolant Sample (Level 1) - Obtain
Cat Monitoring System Numeric Readout Mode
953C Track-Type Loader Hydraulic System Hydraulic Tank and Filter
615C Series II Wheel Tractor-Scraper Wheel Tractor Power Train Axle Shaft - Remove
953C Track-Type Loader Power Train Electronic Control Module Manifold
2003/05/19 Correction to Testing and Adjusting , "Ride Control Accumulator - Test and Charge" {5077}
AD30 Underground Articulated Truck Machine Electrical System Electrical Power Supply
AD30 Underground Articulated Truck Machine Electrical System Battery Disconnect Switch
Cat Digital Voltage Regulator General Information
953C Track-Type Loader Hydraulic System Lift Cylinder
G3500B Engines Cooling System
D6N Track-Type Tractor Power Train Steering Clutch and Brake - Disassemble
D6N Track-Type Tractor Power Train Steering Clutch and Brake - Assemble
950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Power Train Transmission Planetary - Assemble
953C, 963C and 973C Track-Type Loaders Transmission Electronic Control System E283 Low Hydraulic Charge Pressure
980H Wheel Loader Service Brake Control
953C, 963C and 973C Track-Type Loaders Transmission Electronic Control System E623 Low Left Track Forward Steering Pressure
953C, 963C and 973C Track-Type Loaders Transmission Electronic Control System E624 Low Left Track Reverse Steering Pressure
953C, 963C and 973C Track-Type Loaders Transmission Electronic Control System E625 Low Right Track Forward Steering Pressure
953C, 963C and 973C Track-Type Loaders Transmission Electronic Control System E626 Low Right Track Reverse Steering Pressure