836G Landfill Compactor and 834G Wheel Dozer Daily Inspection Caterpillar


Daily Inspection
`

------ WARNING! ------

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.

At operating temperature, the engine coolant is hot and under pressure.

Steam can cause personal injury.

Check the coolant level only after the engine has been stopped and the cooling system pressure cap is cool enough to touch with your bare hand.

Remove the cooling system pressure cap slowly to relieve pressure.

Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.



NOTICE

Accumulated grease and oil on a machine is a fire hazard. Remove this debris with steam cleaning or high pressure water, at least every 1000 hours or each time any significant quantity of oil is spilled on a machine.


For maximum service life of the machine, perform a thorough walk-around inspection before you mount the machine and before you start the engine.

Look around the machine and under the machine. Look for trash buildup, dirt buildup, loose bolts, oil leaks, coolant leaks, broken parts, cracked parts or worn parts.

Note: Watch closely for leaks. If you observe a leak, find the source of the leak and correct the leak. If you suspect a leak or you observe a leak, check the fluid levels more frequently.

Inspect the condition of the equipment and of the hydraulic components.

Check the oil levels, the coolant level, and the fuel level.

Remove any trash buildup and debris. Make all necessary repairs before you operate the machine.

Make sure that all covers and guards are securely attached.

Adjust the mirrors for the correct rear view of the machine.

Inspect the hydraulic cylinders for damage or for excessive wear. Inspect the linkage and the attachment for damage or for excessive wear. Make any necessary repairs.

Grease all of the fittings that need to be serviced on a daily basis.

Reference: Refer to Operation and Maintenance Manual, "Walk-Around Inspection" in the Maintenance Section for detailed instructions on performing a walk-around inspection.

Information System:

D11R Track-Type Tractor Hydraulic System Return Screen - Clean
2003/05/12 New Bearing and Bearing Cap Improves Service Life {6062, 7115}
980G Series II Wheel Loader Rated Load
980G Series II Wheel Loader Specifications
TH220B, TH330B and TH340B Telehandlers Hydraulic System Electrical Input Components
Torque Converter Output Temperature and Hydraulic Tank Temperature Correction for Certain Track Type Tractors{7490}
966G II and 972G II Wheel Loaders Rated Load
963C Track-Type Loader Additional Messages
Installation of Double Lip Wiper Seal{7562}
2003/05/19 A New Pressure Switch for the Torque Converter Lockup is Now Used {1435, 3101}
Installation of the 156-7013 Radiator Field Upgrade Kit on the 994 Wheel Loader{1353}
963C Track-Type Loader Safety Messages
Finding the Top Center Position for No. 1 Piston on a D6R Series II Track-Type Tractor{1105}
980G Series II Wheel Loader Operator Controls
988G Wheel Loader Warning Categories (Caterpillar Monitoring System)
AD30 Underground Articulated Truck Machine Electrical System Engine Start
AD30 Underground Articulated Truck Machine Electrical System Engine Stop
AD30 Underground Articulated Truck Machine Electrical System Engine Shutdown
AD30 Underground Articulated Truck Machine Electrical System Engine Monitoring
AD30 Underground Articulated Truck Machine Electrical System Retarder
AD30 Underground Articulated Truck Machine Electrical System Torque Converter Oil Temperature
AD30 Underground Articulated Truck Machine Electrical System Actual Gear Indicator
TH220B, TH330B and TH340B Telehandlers Boom Wear Pad Clearance - Inspect/Adjust
988G Wheel Loader Seat