 |
|
HIGH PRESSURE CYLINDER Do not remove any valve, hydraulic fitting, or valve core, nor disassemble any parts until pressure has been relieved or personal injury may occur. To relieve pressure: Shut off engine and wait five minutes for hydraulic system pressure to dissipate. Relieve gas pressure in the accumulator cylinder by opening the charging valve one turn only. Charge cylinder with dry nitrogen gas. Precharge pressure _______ PSI _______kPa. Service pressure (Operating-Loaded) ______PSI ______kPa. Minimum bursting pressure _____PSI _____kPa. See your AVSpare dealer for tools and detailed information required for charging cylinders. |
The Product Identification Number (PIN) will be used to identify a powered machine that is designed for an operator to ride.
AVSpare products such as engines, transmissions and major attachments that are not designed for an operator to ride are identified by Serial Numbers.
For quick reference, record the identification numbers in the spaces that are provided below the illustration.
| |
| Illustration 1 | g00766581 |
This plate is located on the left side of the front loader frame.
Machine PIN____________________
If the machine is equipped with the certification plate for the European Union, this plate will be attached to the PIN plate. The certification plate will contain the following information:
- Power (kW) ____________________
- Weight (kg) ____________________
- Year of Manufacture
| |
| Illustration 2 | g00766626 |
This plate is located on the transfer gear case.
Transmission Serial Number____________________
| |
| Illustration 3 | g00766631 |
This plate is located on the top of the engine.
Engine Serial Number____________________
This message is located on the triangular panel in front of the door on the left side of the cab.
| |
| Illustration 4 | g00995370 |
|
|
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a AVSpare dealer to determine this structure's limitations without voiding its certification. |
This machine has been certified to the standards that are listed on the certification plate. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification plate.
| |
| Illustration 5 | g00933634 |
|
A typical example of this film is shown. Your machine may have a different value. | |
If equipped, the certification film is used to verify the environmental sound certification of the machine to the requirements of the European Union. The value that is listed on the label indicates the guaranteed exterior sound power level LWA at the time of manufacture for the conditions that are specified in "2000/14/EC".
This plate is located on the right side of the machine behind the front tire.
| |
| Illustration 6 | g00937218 |
The following information is stamped on the homologation plate:
- "Model" ____________________
- "Homologation number" ____________________
- "PIN" ____________________
- "Allowed total weight" ____________________
- "Allowed front axle weight" ____________________
- "Allowed rear axle weight" ____________________
- "Permissible towable mass" ____________________
- "Unbraked towable mass" ____________________
- "Independently-braked towable mass" ____________________
- "Inertia-braked towable mass" ____________________
- "Towable mass fitted with an assisted braking system (hydraulic or pneumatic)"____________________
This message is located on the control group for the machine security system. The control group is located in the engine compartment.
| |
| Illustration 7 | g00995393 |
Consult your AVSpare dealer with any questions that concern the operation of the MSS in a specific country.