TH62, TH63, TH82 and TH83 Telehandlers Engine Starting Caterpillar

Engine Starting

TH62, TH63, TH82 and TH83 Telehandlers [SEBU7370]

TH62, TH63, TH82 and TH83 Telehandlers Work Tools

TH62, TH63, TH82 and TH83 Telehandlers Reference Material

ENGINE ARRANGEMENT

TH62, TH63, TH82 and TH83 Telehandlers Before Starting Engine

TH62, TH63, TH82 and TH83 Telehandlers Plate Locations and Film Locations

TH62, TH63, TH82 and TH83 Telehandlers Engine Starting with Jump Start Cables

1.1. Starting Above 0 °C (32°F)

2.1. Starting Below 0 °C (32°F)

Starting Above 0 °C (32°F)

Show/hide table

Diesel engine exhaust contains products of combustion which may be harmful to your health

Always start and operate the engine in a well-ventilated area and, if in an enclosed area, vent the exhaust to the outside.

Show/hide table




Illustration 1	g00715188

Ensure that the seat and the steering column are correctly adjusted. Fasten the seat belt.
Show/hide table

Illustration 2 g00711766
Ensure that the transmission control is in the NEUTRAL position (N). The engine will not start unless the transmission control is in the NEUTRAL position.
Show/hide table

Illustration 3 g00712102
Ensure that the parking brake is engaged.
Show/hide table

Illustration 4 g00713357
Before you crank the engine, depress the accelerator control (pedal) slightly. Turn the engine start switch key to the START position in order to start the engine. Release the engine start switch key when the engine starts. Allow the engine to operate at low idle.

Show/hide table

NOTICE

Do not crank the engine for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking again. Turbocharger (if equipped) damage can result, if the engine rpm is not kept low until the engine oil light/gauge verifies the oil pressure is sufficient.

Starting Below 0 °C (32°F)

Show/hide table

If equipped with an air inlet heater (AIH) for cold weather starting, do not use aerosal types of starting aids such as ether. Such use could result in an explosion and personal injury.

Show/hide table




Illustration 5	g00715188

Ensure that your seat and the steering column are correctly adjusted. Fasten your seat belt.
Show/hide table

Illustration 6 g00711766
Ensure that the transmission control is in the NEUTRAL position (N). The engine will not start unless the transmission control is in NEUTRAL.
Show/hide table

Illustration 7 g00712102
Ensure that the parking brake is engaged.
Show/hide table

Illustration 8 g00709343
Push the top of the air inlet heater starting aid (switch) and hold for thirty seconds.
Show/hide table

Illustration 9 g00713357
While you are still operating the switch, turn the engine start switch key to the START position in order to start the engine. When the engine starts, hold down the starting aid switch for a few seconds more and then release the starting aid switch. If the engine does not run smoothly, press and hold down the starting aid switch again until the engine is running smoothly.
Allow the engine to warm up for several minutes. The actual time depends on the outside temperature. Use the latter part of this time to help warm up the hydraulic oil by operating the joystick control in order to raise the boom and lower the boom.

For starting below −18°C (0°F), the use of additional cold weather starting aids is recommended. Any of the following may be required.

A coolant heater
A fuel heater
An oil heater
An extra capacity battery

Before you operate the machine in temperatures below −23°C (−10°F), consult your AVSpare dealer or see Operation and Maintenance Manual, SEBU5898, "Cold Weather Recommendations".