953C Track-Type Loader Engine Oil Level - Check Caterpillar


Engine Oil Level - Check
`

------ WARNING! ------

Hot oil and components can cause personal injury.

Do not allow hot oil or components to contact skin.



NOTICE

Do not under fill or overfill engine crankcase with oil. Either condition can cause engine damage.




Illustration 1g00987539

  1. Open the rear access door that is on the right side of the machine behind the operator's compartment.


    Illustration 2g00991459

  2. Check the dipstick (1) while the engine is stopped. Maintain the oil level between the "LOW" mark and the "FULL" mark.

    Note: When you operate the machine on severe slopes, the oil level in the engine crankcase must be at the "FULL" mark on the dipstick.

  3. Remove oil filler cap (2). If necessary, add oil.

  4. Clean the oil filler cap and install the oil filler cap.

  5. Close the access door.

Information System:

Bench Test Procedure for a 928G Wheel Loader andIT28G Integrated Toolcarrier Transmission with a Flexible Coupling Drive{3030, 3066, 3073}
525D, 535D, 545D, 555D Wheel Skidder Grapple Snubber - Inspect/Adjust
525B and 535B Wheel Skidders Additional Messages
525B and 535B Wheel Skidders Safety Messages
924G and 924GZ Wheel Loaders Machine Systems Main Control Valve - Assemble
924G and 924GZ Wheel Loaders Machine Systems Main Control Valve - Disassemble
3126B Engine for Caterpillar Built Machines System Configuration Parameters
AD30 Underground Articulated Truck Steering System Oil Filter - Replace
AD45B Underground Articulated Truck Oscillating Hitch - Adjust
2003/07/14 Correction to Systems Operation , "Selector and Pressure Control Valve" {3073, 3157}
AD30 Underground Articulated Truck Tailgate Retaining Pin
C-9 Engine for the 973C Track-Type Loader Engine Will Not Crank
2003/04/14 There is New Information on the Oil Grade Plug {1000, 1348}
953C Track-Type Loader Engine Oil and Filter - Change
525B and 535B Wheel Skidders Lifting and Tying Down the Machine
IT28G Integrated Toolcarrier and 924G, 924GZ and 928G Wheel Loaders Engine Supplement Hydraulic and Transmission Oil Cooler - Remove
2003/04/14 Larger Fasteners Are Now Used on the Engine Bracket for the Governor Cable {1265, 1276}
973K Track-Type Loader Final Drive Oil - Change
D6N Track-Type Tractor Power Train Brake Control Valve - Disassemble
D6N Track-Type Tractor Power Train Brake Control Valve - Assemble
IT28G Integrated Toolcarrier and 924G, 924GZ and 928G Wheel Loaders Engine Supplement Hydraulic and Transmission Oil Cooler - Install
AD30 Underground Articulated Truck Hydraulic Tank Screen - Clean
AD30 Underground Articulated Truck Reference Material
990 Series II Wheel Loader Machine Systems Bucket - Remove