AD45B Underground Articulated Truck Oscillating Hitch

Oscillating Hitch - Adjust

AD45B Underground Articulated Truck [SEBU7335]

AD45B Underground Articulated Truck Seat

AD45B Underground Articulated Truck Cooling System Water Temperature Regulator - Replace

FRAME AND BODY

AD45B Underground Articulated Truck Oscillating Hitch - Adjust

AD45B Underground Articulated Truck Frame and Body - Inspect

AD45B Underground Articulated Truck Frame and Body Support Pads - Clean/Inspect

AD45B Underground Articulated Truck Oscillating Hitch - Lubricate

Show/hide table

Personal injury or death can result from machine articulation or movement.
Machine frames can move and a person can be crushed.
Connect the steering frame lock link between the front and rear frames before working on machine. Secure clevis pin with locking pin.
Before operating the machine, fasten the steering frame lock link into the stored position and secure the clevis pin with locking pin.

Failure to lock into the stored position before operating can result in loss of steering.

Park the machine on a level surface.

Relieve the tension from the oscillating hitch. Place a large block of timber behind the rear wheels of the machine and reverse the machine against the block.

Engage the parking brake and stop the engine.

Show/hide table




Illustration 1	g00992525

Remove three bolts (1) and remove locking plate (2) .

Show/hide table




Illustration 2	g00992526

Reposition locking plate (2) so that hole (5) is outside of the circumference of thrust flange (3) .

Insert a 3/4 inch square drive through hole (5) so that the square drive contacts the outside of thrust flange (3). The square drive will prevent locking plate (2) from rotating clockwise.

Use a suitable wrench on the square drive in order to turn thrust flange (3) clockwise until all end play has been removed.

If necessary, turn the thrust flange counterclockwise in order to line up the holes. Insert the square drive into hole (4) in order to rotate the thrust flange counterclockwise. Rotate the thrust flange as far as the first correct hole alignment.