AD30 Underground Articulated Truck Radiator Core - Clean Caterpillar


Radiator Core - Clean
`


To access the radiator for cleaning, perform the following procedure.




    Illustration 1g01805013

    (1) Latch

  1. Release latch (1) and open the grille at the front of the machine.



    Illustration 2g01805014

    (2) Radiator core

    (3) Air conditioning condenser




    Illustration 3g00907092

  1. You can use compressed air, high pressure water or steam to remove dust and other debris from the radiator core. However, the use of compressed air is preferred.

    Note: Care must be taken when you are using high pressure water. High pressure water can cause damage to the radiator. Using a water spray nozzle on the pressure washer which will disperse the water pressure is preferred.

  1. Close the grille.

ReferenceFor the complete procedure for cleaning the radiator core, refer to Special Publication, SEBD0518, "Know Your Cooling System" for the machine that is being serviced.

Information System:

AD30 Underground Articulated Truck Fuel Tank Cap and Strainer - Clean
973C Track-Type Loader Steel Mill Arrangement Maintenance Interval Schedule
2003/05/26 Improved Brakes Are Now Used {4131}
3054E Industrial Engine Crankshaft Rear Seal - Remove
938G Wheel Loader and IT38G Integrated Toolcarrier Engine Starting
AD30 Underground Articulated Truck Hydraulic System Oil - Change
AD30 Underground Articulated Truck Fuel System Primary Filter (Water Separator) - Drain
834H Wheel Dozer and 836H Landfill Compactor Safety Messages
988H Wheel Loader Safety Messages
Procedure for Reinforcing the Mounting Area of the Steering Cylinder on the Rear Frame{7051}
AD30 Underground Articulated Truck Fuel System Primary Filter - Clean/Replace
AD30 Underground Articulated Truck Frame and Body Support Pads - Clean/Inspect
AD30 Underground Articulated Truck Pressure Sensor (Transmission Oil) - Test - If Equipped
AD30 Underground Articulated Truck Hydraulic System Oil Filter (Pilot) - Replace
963C Track-Type Loader Power Train Transmission Stall - Test
938G Wheel Loader and IT38G Integrated Toolcarrier Seat
938G Wheel Loader and IT38G Integrated Toolcarrier Reference Material
3054E Industrial Engine Flywheel - Install
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Hydraulic System Troubleshooting
D6N Track-Type Tractor Power Train Steering Differential and Brake - Assemble
D6N Track-Type Tractor Power Train Axle - Remove and Install
953C Track-Type Loader Engine Starting with Jump Start Cables
CAES Installation For Wheel Loader{7604}
CAES Installation For Wheel Tractor Scraper{7604}