Engine Oil Level - Check
`
AD30 Underground Articulated Truck
[SEBU7328]
AD30 Underground Articulated Truck
Transmission Oil Level - Check
AD30 Underground Articulated Truck
Frame and Body - Inspect
BASIC ENGINE
PAN GP-OIL
AD30 Underground Articulated Truck
Engine Oil Level - Check
AD30 Underground Articulated Truck
Engine Oil and Filter - Change
Show/hide table
| NOTICE |
|---|
Do not underfill or overfill the engine crankcase with oil. Either condition can cause engine damage. |
Show/hide table
 | |
| Illustration 1 | g01803475 |
Check the engine oil level with the machine level and the parking brake engaged.
The dipstick is located on the right side of the engine.
- Before starting the engine, the oil level must be in the hatched area on the SAFE STARTING RANGE ENGINE STOPPED side of dipstick (2) .
Show/hide table
 | |
| Illustration 2 | g01803476 |
- With the engine running and the oil warm, maintain the oil level in the hatched area on the SAFE OPERATING RANGE ENGINE RUNNING side of dipstick (2) .
- Remove filler cap (1) and add oil if necessary.
- Clean the filler cap and install the filler cap.
Information System:
AD30 Underground Articulated Truck
Transmission Oil Level - Check
3054E Industrial Engine
Inlet Air Temperature Sensor - Remove and Install
2003/04/07
Latest Version of Payload Control System (PCS) Software Is Now Available {7620}
2003/04/14
Special Instruction, REHS1640, "Additional Documentation for the Payload Control System" Is Available {0374, 7494}
953C Track-Type Loader
Hydraulic System Oil - Change
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders
Additional Messages
966G Series II Wheel Loader and 972G Series II Wheel Loader Steering System
Metering Pump (HMU)
966H Wheel Loader and 972H Wheel Loader Braking and Hydraulic Fan System
Service Brakes
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders
Hydraulic System Oil Sample - Obtain
3054E Industrial Engine
Boost Pressure Sensor - Remove and Install
C18 Industrial Engines
Starting the Engine
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System
Implement System - Pilot Hydraulics
3054E Industrial Engine
Speed/Timing Sensor - Remove and Install
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System
Pilot Valve (Oil Manifold) - Electrohydraulic Machines
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders
Operator Controls
Bench Test Procedure for a D9 and D9R Track-Type Tractor Transmission {3030, 3073}
2003/05/19
Additional Information for Testing and Adjusting , "Pump Flow - Test" on the Wheel Skidders {4268, 5070}
2003/11/17
New Fan Guards Are Now Used {1360}
953C Track-Type Loader
Hydrostatic Transmission and Hydraulic System Filters - Replace
3054E Industrial Engine
Electronic Control Module - Remove and Install
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System
Lift Kickout - Adjust
AD30 Underground Articulated Truck
Frame and Body - Inspect
AD30 Underground Articulated Truck
Engine Oil and Filter - Change
AD30 Underground Articulated Truck
Frame and Body Support Pads - Clean/Inspect