IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Additional Messages Caterpillar


Additional Messages
`


Illustration 1g00990499

There are several specific messages on this machine. The exact location of the messages and the description of the messages are reviewed in this section. Please become familiarized with all messages.

Make sure that all of the messages are legible. Clean the messages or replace the messages if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the messages, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. Loose adhesive will allow the messages to fall.

Replace any message that is damaged, or missing. If a message is attached to a part that is replaced, install a message on the replacement part. Any AVSpare dealer can provide new messages.

Alternate Exit (1)

This message is located on the latch of the right side window in the cab.



Illustration 2g00915912

If the primary exit is blocked, pull the pin from the latch and release the latch. Push the window outward. Exit the machine through the window.

Air Conditioner (2)

This message is located on the left side of the support base for the seat.



Illustration 3g00990500

Read the service manual before you perform any maintenance on the air conditioner.

Information System:

966G Series II Wheel Loader and 972G Series II Wheel Loader Steering System Metering Pump (HMU)
966H Wheel Loader and 972H Wheel Loader Braking and Hydraulic Fan System Service Brakes
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Hydraulic System Oil Sample - Obtain
3054E Industrial Engine Boost Pressure Sensor - Remove and Install
C18 Industrial Engines Starting the Engine
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Implement System - Pilot Hydraulics
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Implement System - Electrohydraulic System
AD30 Underground Articulated Truck Transmission Oil Filter - Replace
AD30 Underground Articulated Truck Transmission Oil - Change
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Pilot Operated Hydraulic Control
2003/11/17 Changes to the Mounting Hardware Improve the Service Life of the Rear Frame {7051}
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Electrohydraulic Control
953C Track-Type Loader Hydraulic System Oil - Change
2003/04/14 Special Instruction, REHS1640, "Additional Documentation for the Payload Control System" Is Available {0374, 7494}
2003/04/07 Latest Version of Payload Control System (PCS) Software Is Now Available {7620}
3054E Industrial Engine Inlet Air Temperature Sensor - Remove and Install
AD30 Underground Articulated Truck Transmission Oil Level - Check
AD30 Underground Articulated Truck Engine Oil Level - Check
3054E Industrial Engine Speed/Timing Sensor - Remove and Install
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Pilot Valve (Oil Manifold) - Electrohydraulic Machines
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Operator Controls
Bench Test Procedure for a D9 and D9R Track-Type Tractor Transmission {3030, 3073}
2003/05/19 Additional Information for Testing and Adjusting , "Pump Flow - Test" on the Wheel Skidders {4268, 5070}
2003/11/17 New Fan Guards Are Now Used {1360}