IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Hydraulic System Oil Sample - Obtain Caterpillar


Hydraulic System Oil Sample - Obtain
`
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders [SEBU7018]
HYDRAULIC SYSTEM
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Hydraulic System Oil Sample - Obtain


NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "AVSpare Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on AVSpare products.

Dispose of all fluids according to local regulations and mandates.


  1. Operate the machine for a few minutes before obtaining the oil sample. Operate the hydraulic controls. This will thoroughly mix the hydraulic oil for a more accurate sample.


    Illustration 1g00990418

  2. Open the engine access door on the left side of the machine. The sampling valve for the hydraulic oil is located on the hydraulic oil filter base beneath the cab on the left side of the machine.


    Illustration 2g00994422

  3. Use the in-line sampling valve in order to obtain a sample of hydraulic oil.

  4. Close the engine access door.

Reference: For more information, refer to Special Publication, SEBU6250, "AVSpare Machine Fluids Recommendations", "S·O·S Oil Analysis" and Special Publication, PEHP6001, "How To Take A Good Oil Sample".

Information System:

3054E Industrial Engine Boost Pressure Sensor - Remove and Install
C18 Industrial Engines Starting the Engine
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Implement System - Pilot Hydraulics
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Implement System - Electrohydraulic System
AD30 Underground Articulated Truck Transmission Oil Filter - Replace
AD30 Underground Articulated Truck Transmission Oil - Change
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Pilot Operated Hydraulic Control
2003/11/17 Changes to the Mounting Hardware Improve the Service Life of the Rear Frame {7051}
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Electrohydraulic Control
Installation of Product Link{7602}
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Relief Valve
C7 Engines for Caterpillar Built Machines Camshaft Bearings - Remove and Install
966H Wheel Loader and 972H Wheel Loader Braking and Hydraulic Fan System Service Brakes
966G Series II Wheel Loader and 972G Series II Wheel Loader Steering System Metering Pump (HMU)
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Additional Messages
953C Track-Type Loader Hydraulic System Oil - Change
2003/04/14 Special Instruction, REHS1640, "Additional Documentation for the Payload Control System" Is Available {0374, 7494}
2003/04/07 Latest Version of Payload Control System (PCS) Software Is Now Available {7620}
3054E Industrial Engine Inlet Air Temperature Sensor - Remove and Install
AD30 Underground Articulated Truck Transmission Oil Level - Check
AD30 Underground Articulated Truck Engine Oil Level - Check
3054E Industrial Engine Speed/Timing Sensor - Remove and Install
966G Series II Wheel Loader and 972G Series II Wheel Loader Hydraulic System Pilot Valve (Oil Manifold) - Electrohydraulic Machines
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Operator Controls