| |
| Illustration 1 | g00987200 |
| |
| Illustration 2 | g00987072 |
There are several specific safety messages on this machine. The exact location of the hazards and the description of the hazards are reviewed in this section. Please become familiarized with all safety messages.
Make sure that all of the safety messages are legible. Clean the safety messages or replace the safety messages if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the safety messages, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the safety messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety message. Loose adhesive will allow the safety message to fall.
Replace any safety message that is damaged, or missing. If a safety message is attached to a part that is replaced, install a safety sign on the replacement part. Any AVSpare dealer can provide a new safety message.
This safety message is located in the cab of the machine on the left side of the control console.
| |
| Illustration 3 | g00920762 |
 |
|
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your AVSpare dealer for replacement manuals. Proper care is your responsibility. |
Do Not Weld On ROPS/FOPS Structure (2)
This safety message is located in the cab of the machine on the left side of the control console.
| |
| Illustration 4 | g01000261 |
|
|
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. This will void the certification. Consult a AVSpare dealer to determine this structure's limitations without voiding its certification. |
Product Link (3) (If Equipped)
This message is located in the cab on the right hand side.
| |
| Illustration 5 | g01000248 |
|
|
This machine is equipped with a AVSpare Product Link radio communication device which must be deactivated within |
This safety message is located in the front left hand door.
| |
| Illustration 6 | g01000254 |
|
|
Accumulator and lines under high pressure. Disconnecting or disassembly while pressurized can result in personal injury or death. Refer to the service manual for instructions. |
Hot Coolant Under Pressure (5)
This safety message is located on the inside of the door for the radiator filler cap.
| |
| Illustration 7 | g00782457 |
|
|
Pressurized system: Hot coolant can cause serious burn. To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure. |
Improper Connection of the Jump Start Cable (6)
This safety message is located in the cab on the right hand side.
| |
| Illustration 8 | g00947488 |
|
|
Improper jumper cable connections may cause an explosion resulting in personal injury. Batteries may be located in separate compartments. When using jumper cables, always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (−) cable from external source to starter negative (−) terminal. (If not equipped with starter negative terminal, connect to engine block.) Follow procedure in the Operation and Maintenance Manual. |
The warning tag is positioned on the access cover for the track adjuster on both roller frames.
| |
| Illustration 9 | g00950886 |
|
|
High Pressure Cylinder. Do not remove any parts until all pressure has been relieved to avoid possible personal injury. Relieve pressure by opening relief valve one turn maximum. See the Operation and Maintenance Manual for correct procedure. |