Engine Starting Above
| |
| Illustration 1 | g00038881 |
- Move the transmission direction control lever to the NEUTRAL position.
Show/hide table
Illustration 2 g00100014 - Use the engine start switch key (1) in order to unlock the parking brake. The parking brake switch (2) must be ENGAGED.
Show/hide table
Illustration 3 g00828420 - Move the implement control levers to the HOLD position. Activate the lockout control for the implements.
Show/hide table
Illustration 4 g00275817 - Turn the battery disconnect switch to the ON position. The battery disconnect switch is inside of the access door on the left side of the machine.
Show/hide table
Illustration 5 g00674934 - Turn the key start switch to the ON position. The system performs an automatic self test. When you turn on the start switch key the test is performed. If the test is complete without any faults, proceed to next step. If the system detects a fault, check the electrical system. Make all of the necessary repairs before you start the engine.
Show/hide table
Illustration 6 g00674939 - Turn the start switch to the START position. Crank the engine. Release the key when the engine starts.
| NOTICE |
|---|
|
Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking the engine again. Turbocharger damage can result, if the engine speed is not kept low until the engine oil gauge verifies the oil pressure is sufficient. |
Engine Starting Below
| NOTICE |
|---|
|
Inject starting aid (ether), only while cranking the engine, or after initial start-up, until the engine is running smoothly. Use sparingly. Excessive ether without cranking can cause piston and ring damage. Wait approximately two seconds before injecting again. Use ether for cold starting purposes only. After 30 seconds of engine cranking, allow two minutes for starting motor to cool before cranking again. Turbocharger damage can result, if the engine speed is not kept low until the engine oil gauge verifies the oil pressure is sufficient. |
| |
| Illustration 7 | g00038905 |
- Move the transmission direction control lever to the NEUTRAL position.
Show/hide table
Illustration 8 g00100011 - Use the engine start switch key (1) in order to unlock the parking brake (2).
Show/hide table
Illustration 9 g00828454 - Move the implement control levers to the HOLD position. Activate the lockout control for the implements.
Show/hide table
Illustration 10 g00275817 - Turn the battery disconnect switch to the ON position. The battery disconnect switch is inside of the access door on the left side of the machine.
Show/hide table
Illustration 11 g00674934 - Turn the key start switch to the ON position. The system performs an automatic self test. When you turn on the start switch key the test is performed. If the system detects a fault, check the electrical system. Make all of the necessary repairs before you start the engine.
Show/hide table
Illustration 12 g00674939 - Turn the start switch to the START position. Crank the engine. Release the key when the engine starts.
Note: The ether injection system is automatic. Ether injection is controlled by the electronic control module for the engine.
After the engine starts, ether can be manually injected by pushing and releasing the top of the rocker switch until the engine is running smoothly. Manual injection is limited by the electronic control module.
For starting below
At temperatures below