Note: In machines with ripper controls that are not equipped with rippers, the ripper controls are disabled in ET. The controls are disabled in order to prevent inadvertent control operations.
| |
| Illustration 1 | g00824698 |
|
Lower (1) - Push the bottom of the ripper lift control lever in order to lower the ripper. Release the lever. The lever will return to the HOLD position. |
|
Hold (2) - The ripper lever automatically returns to the HOLD position. Ripper movement stops. |
|
Raise (3) - Push the top of the ripper lift control lever in order to raise the ripper. Release the lever. The lever will return to the HOLD position. |
| |
| Illustration 2 | g00824700 |
|
Shank In (4) - Pull the front of the ripper shank in/out lever toward the operator in order to move the shank in closer to the machine. Release the lever. The lever will return to HOLD position. |
|
|
Hold (5) - The ripper shank in/out lever returns to the HOLD position. Ripper movement stops. |
|
Shank Out (6) - Pull the rear of the ripper shank in/out lever toward the operator in order to move the shank out away from the machine. Release the lever. The lever will return to HOLD position. |
| |
| Illustration 3 | g00824706 |
Push the ripper auto stow switch on the ripper control in order to raise the ripper to maximum height. If the machine is configured move the ripper to a full SHANK IN position.
While the ripper auto stow function is moving the ripper, press the ripper auto stow switch again in order to stop ripper movement.