651E Wheel Tractor-Scraper Cooling System Water Temperature Regulator - Replace Caterpillar


Cooling System Water Temperature Regulator - Replace
`
651E Wheel Tractor-Scraper [SEBU6963]
COOLING SYSTEM
LINES GP-WATER
651E Wheel Tractor-Scraper Cooling System Water Temperature Regulator - Replace


NOTICE

Failure to replace the engine's water temperature regulator on a regularly scheduled basis could cause severe engine damage.



NOTICE

The water temperature regulators may be reused if the water temperature regulators are within test specifications, are not damaged, and do not have excessive buildup of deposits.



NOTICE

Since AVSpare engines incorporate a shunt design cooling system, it is mandatory to always operate the engine with a water temperature regulator.

Depending on load, failure to operate with a water temperature regulator could result in either an overheating or an overcooling condition.



NOTICE

If the water temperature regulator is installed incorrectly, it will cause the engine to overheat.


Replace the water temperature regulator on a regular basis. Regular replacement of the temperature regulator will reduce the chance of down time due to problems with the cooling system.

The water temperature regulator should be replaced after the cooling system has been cleaned. Replace the water temperature regulator while the cooling system level is below the housing assembly.

  1. Loosen the hose clamp and remove the hose from the elbow. Disconnect the hose assembly from the water temperature regulator housing.

  1. Remove the bolts from the elbow. Remove the elbow and the water temperature regulator housing.

  1. Remove the gasket, the water temperature regulator, and the seal from the water temperature regulator housing.

  1. Install a new seal in the water temperature regulator housing. Install a new water temperature regulator and a new gasket. Install the water temperature regulator housing on the engine cylinder head.

  1. Install the elbow and the hose. Tighten the hose clamp.

Information System:

IT28G Integrated Toolcarrier and 928G Wheel Loader Clutch (First and Third)
3208 Marine Engine After Stopping Engine
3208 Marine Engine Docking or Reversing Travel Direction
992G Wheel Loader and 854G Wheel Dozer Power Train Transmission Lubrication
IT28G Integrated Toolcarrier and 928G Wheel Loader Clutch (Reverse and Second)
992G Wheel Loader and 854G Wheel Dozer Power Train Transmission Hydraulic System
C15 and C18 Petroleum Generator Sets Engine Operation - Hydrocarbon Mitigation
D6R Track-Type Tractor Refill Capacities
IT28G Integrated Toolcarrier and 928G Wheel Loader Clutch (Forward High and Forward Low)
992G Wheel Loader and 854G Wheel Dozer Power Train Torque Converter
950G Wheel Loader, 962G Wheel Loader and IT62G Integrated Toolcarrier Hydraulic System Bucket Control Group
D6R Track-Type Tractor Steering and Directional Lever
966G and 972G Wheel Loaders Multipurpose Bucket Operation
992G Wheel Loader and 854G Wheel Dozer Power Train Input Transfer Gear And Output Transfer Gear Lubrication
631E Series II Wheel Tractor-Scrapers Engine Valve Lash - Check
IT38F Integrated Toolcarrier and 938F Wheel-Type Loader Secondary Steering System Specification
IT38F Integrated Toolcarrier and 938F Wheel-Type Loader Secondary Steering System System Operation
D7R Track-Type Tractor Engine Air Filter Primary Element - Clean/Replace
D7R Track-Type Tractor Engine Air Filter Secondary Element - Replace
D7R Track-Type Tractor Walk-Around Inspection
IT28G Integrated Toolcarrier and 928G Wheel Loader Transmission Case
IT38F Integrated Toolcarrier and 938F Wheel-Type Loader Secondary Steering System Testing and Adjusting
D7R Track-Type Tractor Hydraulic System Oil - Change
D7R Track-Type Tractor Hydraulic System Oil Filter - Replace