D7R Track-Type Tractor Warning Signs and Labels Caterpillar


Warning Signs and Labels
`
1.1. Do Not Operate
2.1. Do Not Weld On ROPS
3.1. Improper Jump Start Cable Connections
4.1. High Pressure Cylinder

There are several specific warning signs on this machine. The exact location of the hazards and the description of the hazards are reviewed in this section. Please become familiarized with all warning signs.

Make sure that all of the warning signs are legible. Clean the warning signs or replace the warning signs if you cannot read the words. Replace the illustrations if the illustrations are not visible. When you clean the warning signs, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the warning signs. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the warning sign. Loose adhesive will allow the warning sign to fall.

Replace any warning sign that is damaged, or missing. If a warning sign is attached to a part that is replaced, install a warning sign on the replacement part. Any AVSpare dealer can provide new warning signs.

Do Not Operate




Illustration 1g00100262

The warning sign is positioned in the cab. The warning sign is positioned to the left of the operator.




Illustration 2g00038370

------ WARNING! ------

Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any AVSpare dealer for replacement manuals. Proper care is your responsibility.

----------------------

Do Not Weld On ROPS




Illustration 3g00100263

The warning sign is positioned on the vertical support of the ROPS on the right side of the machine.




Illustration 4g00100265

------ WARNING! ------

Structural damage, an overturn, modification, alteration, or improper repair, can impair this structure's protective capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a AVSpare dealer to determine this structure's limitations without voiding its certification.

----------------------

Improper Jump Start Cable Connections




Illustration 5g00100264

The warning tag is positioned on the door of the battery compartment on the left side of the machine.




Illustration 6g00038786

------ WARNING! ------

Improper jumper cable connections can cause an explosion resulting in personal injury.

----------------------

High Pressure Cylinder




Illustration 7g00100390

The warning tag is positioned on the access cover for the track adjuster on both track roller frames.




Illustration 8g00100274

------ WARNING! ------

High Pressure Cylinder. Do not remove any parts until all pressure has been relieved to avoid possible personal injury. Relieve pressure by opening relief valve one turn maximum. See the Operation and Maintenance Manual for correct procedure.

----------------------