Hydraulic System Oil - Change
`
D5M Track-Type Tractor
[SEBU6886]
D5M Track-Type Tractor
Hydraulic System Oil Filter - Replace
D5M Track-Type Tractor
Transmission Oil - Change
HYDRAULIC SYSTEM
MISCELLANEOUS INFORMATION
D5M Track-Type Tractor
Hydraulic System Oil - Change
Operate the machine in order to warm the oil.
Park the machine on level ground. Lower the bulldozer blade to the ground and apply slight downward pressure. Engage the parking brake and stop the engine.
- Remove the hydraulic tank filler cap slowly in order to relieve any pressure.
Show/hide table
Illustration 1 | g00649152 |
- Wash the filler strainer and the filler cap in a clean nonflammable solvent.
- Remove the oil drain plug. The oil drain plug is located under the right rear of the machine.
- Attach a hose to a 1 inch NPT pipe nipple. This 1 inch NPT pipe nipple should have a length of 100 mm (4 inch).
- Install the pipe nipple into the drain plug opening.
- Rotate the pipe nipple clockwise in order to open the internal drain valve. Allow the oil to drain into a suitable container.
- Remove the pipe nipple. The valve for the hydraulic tank will close.
- Clean the drain plug and install the drain plug. Tighten the drain plug to a torque of 68 ± 7 N·m (50 ± 5 lb ft).
- See Operation and Maintenance Manual, "Hydraulic System Oil Filter - Replace". Change the hydraulic system filter.
- Install the filler strainer.
- See Operation and Maintenance Manual, "Refill Capacities" in order to determine the amount of hydraulic oil that is needed to fill the hydraulic oil tank. Fill the hydraulic oil tank.
- Inspect the filler cap gasket. Replace the gasket if damage or wear is evident.
- Install the filler cap.
- Start the engine. Run the engine for a few minutes.
- Maintain the oil level to the "FULL" mark in the sight gauge. Add oil, if necessary.
Show/hide table
Illustration 2 | g00649153 |
- Stop the engine.
Information System:
D5M Track-Type Tractor
Hydraulic System Oil Filter - Replace
3208 Marine Engine
Marine Towing
D6M Track-Type Tractor Power Train
Tracks
D5M Track-Type Tractor
Heating and Air Conditioning Controls
D6R Track-Type Tractor
Seat Adjustment
D6M Track-Type Tractor Power Train
Track Rollers - Single Flange and Double Flange
992G Wheel Loader and 854G Wheel Dozer Power Train
Power Train Electronic Control Pinout Specifications
D5M Track-Type Tractor
Model View Illustrations
D5M Track-Type Tractor
Lifting and Tying Down the Machine
D5M Track-Type Tractor
Ether Starting Aid
D5M Track-Type Tractor
Engine Start Switch
992G Wheel Loader and 854G Wheel Dozer Power Train
Oscillating Axle (Rear)
D5M Track-Type Tractor
Transmission Oil - Change
D5M Track-Type Tractor
Transmission Oil Level - Check
D5M Track-Type Tractor
Walk-Around Inspection
D5M Track-Type Tractor
Starting with Auxiliary Start Receptacle
D5M Track-Type Tractor
Refill Capacities
992G Wheel Loader and 854G Wheel Dozer Power Train
Torque Converter
D6M Track-Type Tractor
Heating and Air Conditioning Controls
3208 Marine Engine
Maintenance Log
D5M Track-Type Tractor
Heating and Air Conditioning Controls
3208 Marine Engine
Standard Torque for Worm Drive Band Hose Clamps
992G Wheel Loader and 854G Wheel Dozer Power Train
Torque Converter (Lockup)
3208 Marine Engine
Metric (ISO) Fasteners