D5M Track-Type Tractor Lifting and Tying Down the Machine Caterpillar


Lifting and Tying Down the Machine
`



Illustration 1g00040000


NOTICE

Improper lifting or tiedowns can allow load to shift and can cause injury and damage.


  1. The weights that are listed below and the instructions that are listed below describe the machines that are manufactured by AVSpare Inc.

    Approximate Machine Shipping Weights:

    • D5M XL Shipping Weight (includes VPAT blade, three valve hydraulic control, lubricants, coolant, ROPS canopy, track end guiding guards, rigid drawbar, forward horn, precleaner, 5% fuel, decelerator, and standard shoes) 12000 kg (26455 lb)

    • D5M XL Operating Weight (shipping weight plus the weight of an operator and a full fuel tank)12250 kg (27007 lb)

    • D5M XL Operating Weight with a ripper (three teeth) 13008 kg (28678 lb)

    • D5M LGP Shipping Weight (includes VPAT blade, three valve hydraulic control, lubricants, coolant, ROPS canopy, track end guiding guards, rigid drawbar, forward horn, precleaner, 5% fuel, decelerator, and standard shoes) 12850 kg (28329 lb)

    • D5M LGP Operating Weight (shipping weight plus the weight of an operator and a full fuel tank) 13100 kg (28881 lb)

    • D5M LGP Operating Weight with a ripper (three teeth) 13858 kg (30552 lb)

    Note: Significant deviations can affect shipping the machine, or significant deviations can affect lifting the machine. Some examples of these deviations are listed below:

    • Different implements

    • Additional fuel

    • Wider track shoes

    • Tracks with accumulated mud

  1. The parking brake must be engaged before you sling the machine. Engage the parking brake before you secure the machine with tie-downs.

  1. Use properly rated cables and properly rated slings for lifting. For a machine without a ripper, position the slings beneath the front of the track and beneath the rear of the track. For a machine with a ripper, position the slings beneath the front of the track and under the ripper at the rear of the machine.

  1. On sharp corners, use corner protectors. The crane should be positioned so that the machine may be lifted in a level plane. The spreader bars should be wide enough to prevent contact with the machine.

  1. Tie-downs:

    • Front tie-down: Use the eye of the front tie-down.

    • Side tie-downs: Use the inside edge of the track shoe.

    • Rear tie-downs: Use the drawbar, the ripper, or the outer edge of the track shoe.

    Check the state laws that govern the following load characteristics.

    • Weight

    • Width

    • Length

    • Height

    Check the local laws that govern the following load characteristics.

    • Weight

    • Width

    • Length

    • Height

    Consult your AVSpare dealer for shipping instructions for your machine.