After Starting Engine
`
D6M Track-Type Tractor
[SEBU6894]
D6M Track-Type Tractor
Starting Below 0°C (32°F)
D6M Track-Type Tractor
Bulldozer Blade Tilt and Angle Control
ENGINE ARRANGEMENT
MISCELLANEOUS INFORMATION
Show/hide table
![]() | |
Illustration 1 | g00655175 |
Show/hide table
NOTICE |
---|
Keep engine speed low until the engine oil pressure registers on the gauge or the engine oil indicator light goes out. If it does not register or the light go out within ten seconds, stop the engine and investigate the cause before starting again. Failure to do so, can cause engine damage. |
- Allow a cold engine to warm up at low idle for at least five minutes. Engage the attachment controls and disengage the attachment controls in order to help warm-up of the hydraulic components.
Cycle all of the controls in order to allow the warm oil to circulate through all of the cylinders and all of the lines.
When you run the engine at low idle in order to warm up the engine, observe the following recommendations.
- If the temperature is over 0°C (+32°F), idle the engine for approximately 15 minutes.
- If the temperature is below 0°C (+32°F), idle the engine for approximately 30 minutes or more.
- If the temperature is below -18°C (0°F), more time may be required in order to warm up the engine.
- If the hydraulics are sluggish, more time may be required in order to warm up the engine.
- If the temperature is over 0°C (+32°F), idle the engine for approximately 15 minutes.
- All fault lights should turn off. The fault alarm should turn off. If the fault lights do not turn off, stop the engine. Make any necessary repairs before you start the engine.
- Frequently look at the action light and the gauge display during operation.
- Look at the hydraulic oil tank and the transmission oil levels. Maintain the oil levels to the "FULL" marks.
Information System:
992G Wheel Loader and 854G Wheel Dozer Braking System
Parking Brake Interlock
992G Wheel Loader and 854G Wheel Dozer Braking System
Parking Brake
651E Wheel Tractor-Scraper
Fuses - Replace
992G Wheel Loader and 854G Wheel Dozer Power Train
Transmission Oil Pump
992G Wheel Loader and 854G Wheel Dozer Braking System
Brake Control Valve (Service)
3208 Marine Engine
Battery Electrolyte Level - Check
992G Wheel Loader and 854G Wheel Dozer Steering System
Steering Control Valve
651E Wheel Tractor-Scraper
Fuel System Secondary Filter - Replace
992G Wheel Loader and 854G Wheel Dozer Power Train
Modulating Valve (Torque Converter Lockup Clutch)
D6M Track-Type Tractor
Starting Below 0°C (32°F)
992G Wheel Loader and 854G Wheel Dozer Braking System
Foot Brake Control
D6M Track-Type Tractor
Braking System - Test
651E Wheel Tractor-Scraper
Hitch - Inspect
651E Wheel Tractor-Scraper
Hydraulic System Oil - Change
D5M Track-Type Tractor
Battery Disconnect Switch
651E Wheel Tractor-Scraper
Hydraulic System Oil Filter - Replace
3208 Marine Engine
English (SAE) Fasteners
D5M Track-Type Tractor
Cab Air Filter - Clean/Replace
D5M Track-Type Tractor
Engine Air Filter Primary Element - Clean/Replace
D5M Track-Type Tractor
Engine Air Filter Secondary Element - Replace
D6M Track-Type Tractor Power Train
Torque Converter
D5M Track-Type Tractor
Engine Oil Level - Check
D5M Track-Type Tractor
Engine Oil and Filter - Change
992G Wheel Loader and 854G Wheel Dozer Braking System
Brake Control Valve (Parking)