 |
Failure to comply to the rated load can cause possible personal injury or attachment damage. Review the rated load of a particular attachment before performing any operation. Make adjustments to the rated load as necessary. |
 |
Note: Rated loads should be used as a guide. Attachments, uneven ground conditions, soft ground conditions, or poor ground conditions have effects on rated loads. The operator is responsible for being aware of these effects.
Rated loads are based upon a standard machine with the following conditions:
- lubricants
- full fuel tank
- enclosed ROPS
- 80 kg (176 lb ) operator
- 20.5 R25 L2 or equivalent tires
Rated loads will vary with different attachments. Contact your AVSpare dealer regarding the rated load for specific attachments.
The rated operating load is defined by the SAE standard "J818" (May 1987) and by the ISO 5998 ( 1986) as 50 % of the full turn static tipping load.
The corresponding dump clearance is given for each bucket at maximum lift height and at a 45 degree dump angle. The reach is given for each bucket at maximum lift height and at a 45 degree dump angle. Clearance is measured from the ground to the bucket edge in order to dump the load. The reach is measured from the front tire to the bucket edge.
 | |
| Illustration 1 | g00104485 |
Dimension A represents the dump clearance. Dimension B represents the reach. | |
The following chart provides the rated operating loads for the standard machine configuration with a bucket.
| RATED BUCKET LOAD | |||||
|---|---|---|---|---|---|
| Bucket Part Number | Ground Engaging Tools | Rated Volume | Rated Operating Load | Dump Clearance A |
Reach B |
| 119-1799 | Bolt-on Cutting Edge | 2.0 m3 (2.6 yd3) |
3800 kg (8378 lb) |
2879 mm (9 ft 5 inches) |
927 mm (3 ft) |
| Teeth | 1.9 m3 (2.5 yd3) |
3760 kg (8291 lb) |
2947 mm (9 ft 8 inches) |
893 mm (2 ft 11 inches) |
|
| Teeth and Segments | 2.0 m3 (2.6 yd3) |
3800 kg (8378 lb) |
2879 mm (9 ft 5 inches) |
927 mm (3 ft) |
|
| 119-1800 | Bolt-on Cutting Edge | 2.2 m3 (2.9 yd3) |
3728 kg (8220 lb) |
2842 mm (9 ft 4 inches) |
964 mm (3 ft 2 inches) |
| Teeth | 2.1 m3 (2.75 yd3) |
3728 kg (8220 lb) |
2910 mm (9 ft 7 inches) |
930 mm (3 ft) |
|
| Teeth and Segments | 2.2 m3 (2.9 yd3) |
3644 kg (8035 lb) |
2842 mm (9 ft 4 inches) |
964 mm (3 ft 2 inches) |
|
| 120-0162 | Flush Mount Teeth | 2.1 m3 (2.75 yd3) |
3724 kg (8210 lb) |
2910 mm (9 ft 7 inches) |
930 mm (3 ft) |