631E Series II Wheel Tractor-Scrapers Gear Oil Caterpillar


Gear Oil
`
631E Series II Wheel Tractor-Scrapers [SEBU6905]
IMPLEMENTS
631E Series II Wheel Tractor-Scrapers Gear Oil
1.1. Applications
2.1. Cat GO (Gear Oil)
3.1. Commercial Gear Oils


NOTICE

Do not use the Cat GO (Gear Oil) or commercial gear oil in the machine compartments unless specifically recommended by AVSpare. The gear oil can cause seals to fail. The seals can also leak. The gear oil may not be compatible with friction materials. The oil can reduce the efficiency of the transmission and the brake performance.


Applications

Gear oils are recommended for use in certain Direct Drive Transmissions, Differentials, Final Drives, Transfer drives, Circle Drives (excavators), and other applications. The details of the applications of these oils are given in the “Lubricant Viscosity” section of this Special Publication.

Cat GO (Gear Oil)

Cat GO offers maximum protection against the following damage: scoring of the gear teeth, pitting of the gear teeth and pitting of the parts in roller bearings. Cat GO provides excellent stability under high temperature conditions. Cat GO also has superior low temperature performance. This oil also gives protection against rust and corrosion. Some applications require additives for the extreme pressures that can occur at the surfaces/edges of the components. For these applications, Cat GO provides the extra protection.

When the use of gear oil is specified, use Cat GO or Cat Synthetic GO in order to maximize the component life.


NOTICE

Cat GO is not the same as Cat TDTO, and does not meet Cat TO-4 or TO-4M oil Performance Requirements. Cat GO or commercial gear oils should not be used in compartments that specify Cat TO-4 or TO-4M oil.



NOTICE

Cat GO is not the same as Cat FDAO, and does not meet the Cat FD-1 oil Performance Requirements. Cat GO or commercial gear oil should not be used in compartments that specify Cat FD-1 oil.


Commercial Gear Oils


NOTICE

Cat does not warrant the quality or performance of non-Cat fluids.


Gear lubricants are classified by the API service category and by the SAE viscosity grade that is defined in "SAE J306".

If the Cat GO or Cat Synthetic GO cannot be used, select a commercial oil that meets the "API GL-5"specification.

Note: Non-AVSpare commercial "API GL-5" gear oils are as a group second choice oils.

Information System:

631E Series II Wheel Tractor-Scrapers Transmission/Drive Train Oil
631E Series II Wheel Tractor-Scrapers Hydraulic Oil
631E Series II Wheel Tractor-Scrapers Engine Oil - Cat Machine Diesel Engines
D6M Track-Type Tractor Transmission Oil - Change
D6M Track-Type Tractor Power Train Steering and Brake Control Valve
631E Series II Wheel Tractor-Scrapers Lubricant Information
D6M Track-Type Tractor Fuel System Primary Filter - Clean/Replace
992G Wheel Loader and 854G Wheel Dozer Steering System Piston Pump (Steering)
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Transmission Oil - Change
Installation of Output Yoke and Screen Housing On Remanufactured Transmissions{3002, 3159}
561M Pipelayer Bevel and Transfer Gears - Power Shift
928G Wheel Loader Walk-Around Inspection
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Multipurpose Tractor Oil
631E Series II Wheel Tractor-Scrapers Lubricating Grease
631E Series II Wheel Tractor-Scrapers Specialty Lubricants
Cat Commercial Diesel Engine Fluids Recommendations Cold Weather Lubricants
D6M Track-Type Tractor Lubricant Viscosities
631E Series II Wheel Tractor-Scrapers S·O·S Services Oil Analysis
631E Series II Wheel Tractor-Scrapers Fuel Recommendations
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors General Coolant Information
631E Series II Wheel Tractor-Scrapers Coolant Recommendations
Cat Commercial Diesel Engine Fluids Recommendations Extended Life Coolant Cooling System Maintenance
3208 Marine Engine S·O·S Coolant Analysis
Cat Commercial Diesel Engine Fluids Recommendations Reference Material