928G Wheel Loader Transmission Oil Filter - Replace Caterpillar

Illustration 1	g00461351

The transmission filter is located on the left side of the machine under the steps.

Illustration 2	g00101969

1. Remove the transmission oil filter element with a strap type wrench.

2. Clean the filter element mounting base. Remove any part of the filter element gasket that remains on the filter element mounting base.

3. Apply a light coat of oil to the gasket of the new filter element.

4. Install the new filter element by hand. When the gasket contacts the mounting base, tighten the filter element for an additional three quarters of a turn.

5. Start the engine and apply the service brake. Slowly operate the transmission controls in order to circulate the transmission oil.

6. Move the transmission control lever to NEUTRAL and engage the parking. Inspect the filter element for leaks.

Show/hide table



Illustration 3	g00101970

7. Maintain the transmission oil level between the "LOW" mark and the "HIGH" mark on the sight gauge when the machine is running. Maintain the transmission oil level to the top of the sight gauge when the machine is not running. Add transmission oil, if necessary.

8. Stop the engine.