928G Wheel Loader Fuel System Primary Filter - Replace Caterpillar


Fuel System Primary Filter - Replace
`
928G Wheel Loader [SEBU7015]
FUEL SYSTEM
FILTER GP-FUEL
928G Wheel Loader Fuel System Primary Filter - Replace


NOTICE

Do not fill fuel filters with fuel before installing them. Contaminated fuel will cause accelerated wear to fuel system parts.





Illustration 1g00449164

The fuel filter is located in the engine compartment on the right side of the machine.

  1. Open the engine access door on the right side of the machine.



    Illustration 2g00101891

  1. Remove the fuel filter. Inspect the fuel filter for debris by cutting the filter open. Discard the filter properly.

  1. Clean the mounting base of the fuel filter. Remove any part of the old seal that remains on the mounting base of the fuel filter.

  1. Coat the seal of the new fuel filter with clean diesel fuel.

  1. Install the new fuel filter by hand. When the seal contacts the base, tighten the filter for an additional three quarters of a turn.

  1. Prime the fuel system. Refer to Operation and Maintenance Manual, "Fuel System - Prime".

  1. Close the engine access door.