928G Wheel Loader Autoshift Control Caterpillar


Autoshift Control
`
928G Wheel Loader [SEBU7015]
ELECTRICAL AND STARTING SYSTEM
CONTROL GP-ELECTRONIC
928G Wheel Loader Autoshift Control



Illustration 1g00455091


Manual Mode (1) - Push the bottom of the switch for the manual mode of the autoshift function.



Illustration 2g00100970

The operator selects the desired speed and the desired direction in the manual mode with the transmission shift lever (3).




Illustration 3g00455094

The downshift switch (4) that is located on the lift lever is only active when the speed selector is in second gear.

Press the downshift switch and release the downshift switch (4) with the machine in second gear. The transmission will downshift to first gear.

The transmission will remain in first gear until a speed change or a direction change is made.


Automatic Mode (2) - Push the top of the switch for the autoshift function in the automatic mode. Push the top of the switch prior to shifting the transmission into forward or reverse in order to activate the autoshift function. The operator selects the highest desired operating speed. The control selects the proper transmission gear according to the version of the machine and to the ground speed of the machine.

Automatic downshifts into first gear are not allowed. Press the downshift switch and release the downshift switch (4). The transmission downshifts one gear speed, provided that an engine overspeed would not occur.

Press the downshift switch and hold down the downshift switch (4) for continued downshifts until the machine is in first gear. The normal autoshift function continues in three seconds after the downshift switch is released.

Information System:

IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Engine Oil and Filter - Change
631E Series II Wheel Tractor-Scrapers Seat Belt
966G and 972G Wheel Loaders Hydraulic System Oil - Change
651E Wheel Tractor-Scraper Heating and Air Conditioning Control
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Hydraulic System Oil Filter - Replace
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Transmission Oil Filter - Replace
651E Wheel Tractor-Scraper Directional Turn Signal and Hazard Flasher Control
928G Wheel Loader Towing the Machine
928G Wheel Loader Lifting and Tying Down the Machine
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Circuit Breakers - Reset
928G Wheel Loader Shipping the Machine
D6M Track-Type Tractor Transmission Oil Level - Check
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Fuel System Primary Filter (Water Separator) Element - Replace
561M Pipelayer Transmission Selector and Pressure Control Valve - Power Shift
966G and 972G Wheel Loaders Secondary Steering - If Equipped
651E Wheel Tractor-Scraper Ejector Control
651E Wheel Tractor-Scraper Engine Starting without Starting Aid
651E Wheel Tractor-Scraper Engine Starting with Ether Starting Aid
627F Wheel Tractor-Scraper Engine Starting with Jump Start Cables
651E Wheel Tractor-Scraper Engine Starting with Auxiliary Start Receptacle
651E Wheel Tractor-Scraper Engine and Machine Warm-Up
651E Wheel Tractor-Scraper Operation Information
928G Wheel Loader Bucket Lift Control
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Engine Air Filter Secondary Element - Replace