D6M Track-Type Tractor Transmission Oil Level - Check Caterpillar


Transmission Oil Level - Check
`

------ WARNING! ------

Hot oil and components can cause personal injury.

Do not allow hot oil or components to contact skin.

----------------------



Illustration 1g00100604

The transmission oil dipstick is behind the access cover on the left side of the machine.




    Illustration 2g00100603

  1. Open the access cover. Check dipstick (1) when the engine is running at low idle and the oil is at operating temperature. Maintain the oil between the "LOW" mark and the "FULL" mark.

    Note: When you are operating the machine on severe slopes, the quantity of oil in the transmission can be increased up to 10 percent. When you are operating with the increased oil quantity, prolonged operation in some machines can cause high transmission oil temperatures. After the work on the severe slopes has been completed, drain the excessive oil quantity from the transmission.

  1. Remove filler plug (2). If necessary, add oil.

  1. Clean the filler plug and install the filler plug.

    Replace the filter element if the transmission oil filter indicator comes on during operation. See Operation and Maintenance Manual, "Transmission Oil Filter - Replace".

  1. Close the access cover.

Information System:

IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Fuses - Replace
D6M Track-Type Tractor Engine Oil Level - Check
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Specifications
928G Wheel Loader Bulldozing and Dumping
854G Wheel Dozer Hydraulic System Hydraulic Tank (Steering, Brake)
928G Wheel Loader Secondary Steering
938G Wheel Loader and IT38G Integrated Toolcarrier Engine Starting with Auxiliary Start Receptacle - If Equipped
D6M Track-Type Tractor Walk-Around Inspection
992G Wheel Loader Electrohydraulic System Pressure Sensor (Implement Pilot Oil)
554 Forwarder and 574 Forwarder Engine Starting with Jump Start Cables
D6M Track-Type Tractor Fuses - Replace
928G Wheel Loader Starting Below 0°C (32°F) with Thermal Starting Aid
928G Wheel Loader Shipping the Machine
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Circuit Breakers - Reset
928G Wheel Loader Lifting and Tying Down the Machine
928G Wheel Loader Towing the Machine
651E Wheel Tractor-Scraper Directional Turn Signal and Hazard Flasher Control
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Transmission Oil Filter - Replace
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Hydraulic System Oil Filter - Replace
651E Wheel Tractor-Scraper Heating and Air Conditioning Control
966G and 972G Wheel Loaders Hydraulic System Oil - Change
631E Series II Wheel Tractor-Scrapers Seat Belt
IT62G Integrated Toolcarrier and 950G and 962G Wheel Loaders Engine Oil and Filter - Change
928G Wheel Loader Autoshift Control