Track Roller Frame Guides - Inspect
` Measure the rotational movement of the front roller frame relative to the rear roller frame.
Show/hide table
![]() | |
Illustration 1 | g00427478 |
Typical example |
- Raise the front of the machine. Place a
100 mm (4 inch) block under the outside edge of a track shoe. Place the block near the front track idler. Lower the machine onto the block.Show/hide tableIllustration 2 g00414726 Typical example - Use a grease pencil to make a mark on the tubular section of the front roller frame. Make a mark on the rear of the roller frame. This mark should correspond with the mark that is on the tubular section.
Show/hide table
Illustration 3 g00427479 Typical example - Raise the front of the machine. Place the block under the inside edge of the same track shoe. Lower the machine onto the block.
Show/hide table
Illustration 4 g00414727 Typical example - Put a mark on the tubular section of the front roller frame. This mark should correspond with the mark on the rear roller frame. Measure the distance between the two marks on the front roller frame.
If the distance between the two marks is greater than
Repeat the entire procedure for the other side of the machine.
Show/hide table
NOTICE |
---|
Never build up the track roller frame guides with hard-face welding. This will cause serious wear damage to the guide slots in the front track roller frame. |
Show/hide table
![]() | |
Illustration 5 | g00039582 |
If dimension (X) is less than
Information System:
D10R Track-Type Tractor
Engine Air Filter Secondary Element - Replace
D10R Track-Type Tractor
Engine Air Filter Primary Element - Clean/Replace
D10R Track-Type Tractor
Braking System - Test
D6R Track-Type Tractor
Winch Wire Rope - Install
D10R Track-Type Tractor
Battery - Inspect
D10R Track-Type Tractor
Belts - Inspect/Adjust/Replace
834B and 836 Landfill Compactor
Starting with Auxiliary Start Receptacle
844 Wheel Dozer
Tree or Brush Removal
D9R Track-Type Tractor
Standard Torque for Worm Drive Band Hose Clamps
D6R Track-Type Tractor
Operation
834B and 836 Landfill Compactor
After Starting Engine
834B and 836 Landfill Compactor
Transmission Oil Filter - Replace
D10R Track-Type Tractor
Engine Oil and Filter - Change
D10R Track-Type Tractor
Engine Oil Level - Check
D10R Track-Type Tractor
Fuel System Secondary Filter - Replace
D10R Track-Type Tractor
Hydraulic System Oil - Change
D10R Track-Type Tractor
Final Drive Oil - Change
D10R Track-Type Tractor
Transmission System Oil Level - Check
D10R Track-Type Tractor
Hydraulic System Oil Filters - Replace
D10R Track-Type Tractor
Hydraulic System Oil Level - Check
D6R Track-Type Tractor
Winch Filter and Magnetic Strainer - Replace/Clean
D6R Track-Type Tractor
Winch Oil - Change
D10R Track-Type Tractor
Final Drive Oil Level - Check
834B and 836 Landfill Compactor
Refill Capacities